Please wait a minute...
中国腐蚀与防护学报  2008, Vol. 28 Issue (5): 307-310          
  论文 本期目录 | 过刊浏览 |
钨铜合金化学镀镍磷镀层在NaCl溶液中的腐蚀行为
郝龙;李锐;江莉;林安;甘复兴
武汉大学资源与环境工程学院环境工程系 湖北 武汉
Corrosion Behavior of Ni-P Deposit on W-Cu Alloy in NaCl Solution
武汉大学资源与环境工程学院环境工程系 湖北 武汉
引用本文:

郝龙; 李锐; 江莉; 林安; 甘复兴 . 钨铜合金化学镀镍磷镀层在NaCl溶液中的腐蚀行为[J]. 中国腐蚀与防护学报, 2008, 28(5): 307-310 .

全文: PDF(996 KB)  
摘要: 采用化学沉积的方法在W-Cu粉末合金上成功地实现了化学镀Ni-P镀层,镀层表面光滑、致密,在结构上属于非晶态;经过25 d的3.5 mass% NaCl溶液浸泡研究表明:在浸泡的前16 d中,化学镀Ni-P镀层的腐蚀速率逐渐增大,在16 d之后腐蚀倾向有所降低;通过腐蚀失重实验得到Ni-P镀层的腐蚀失重小于W-Cu合金,说明化学镀Ni-P镀层可以对W-Cu合金起到保护作用。
关键词 : 钨铜合金,  化学镀,  Ni-P镀层,  腐蚀    
Abstract:The corrosion behavior of Ni-P deposit on W-Cu alloy in 3.5%(wt%) NaCl solution was tested by the polarization curves and electrochemical impedance spectroscopy (EIS). The results indicate that the passive region is not obvious after immersing in 3.5%(wt%) NaCl solution for 0.5 hour and with the increasing of the immersion time the passive membrane becomes integrated and the passive region is becoming obvious after immersing in 3.5%(wt%) NaCl solution for 2 days. After 6 days the point corrosion potential and passive region become smaller and its anti-corrosion ability is getting lower, but the passive parameter is better than that of W-Cu alloy. The polarization curves after immersing in 3.5%(wt%) NaCl solution for 13 days and 29 days were much the same as the one after 6 days and the corrosion behavior of Ni-P alloy in 3.5%(wt%) NaCl solution becomes stable.
Key words:
收稿日期: 2007-02-05     
ZTFLH:  TG146  
[1]Fan J L,Liu J,Yan D J,et al.Study of process of fine-grainedW-Cu composite[J].Powder Metall.,2004,22(2):83-84(范景莲,刘军,严德剑等.细晶钨铜复合材料制备工艺的研究[J].粉末冶金技术,2004,22(2):83-84)
[2]Fan J L,Yan D J,Huang B Y,et al.Current study of R&D ofW-Cu composite materials in China and abroad[J].Powder Met-all.,2003,13(2):9-14(范景莲,严德剑,黄伯云等.国内外钨铜复合材料的研究现状[J].粉末冶金工业,2003,13(2):9-14)
[3]Cai Y X,Liu B W.Compact W-Cu composite materials and its method[J].Powder Metall.,1999,17(2):138-144(蔡一湘,流伯武.钨铜复合材料致密化问题和方法[J].粉末冶金技术,1999,17(2):138-144)
[4]Jiang X X,Shen W.The Fundamental and Practice of ElectrolessPlating[M].Beijing:Defence Industry Press,2000:124(姜晓霞,沈伟.化学镀理论及实践[M].北京:国防工业出版社,2000:124)
[5]Wang S L,Xu X B,Wu H H.Preparation and corrosion proper-ties of electroless Ni-Zn-P alloy deposits[J].J.Chin.Soc.Corros.Prot.,2004,24(5):297-300(王森林,徐旭波,吴辉煌.化学沉积Ni-Zn-P合金制备和腐蚀性能研究[J].中国腐蚀与防护学报,2004,24(5):297-300)
[6]Xia L T,Wei H,Zhu H X.Study of corrosion behavior on com-mon cast iron materials exposed to seawater[J].J.Chin.Soc.Cor-ros.Prot.,2003,23(2):99-102(夏兰廷,韦华,朱宏喜.常用铸铁材料海水腐蚀行为的研究[J].中国腐蚀与防护学报,2003,23(2):99-102)
[7]Gu C D,Lian J S,Li G Y,et al.Electroless Ni-P plating on theAZ91D magnesium alloy[J].J.Chin.Soc.Corros.Prot.,2005,25(5):271-274(谷长栋,连建设,李光玉等.AZ91D镁合金的化学镀镍[J].中国腐蚀与防护学报,2005,25(5):271-274)
[8]Qin X J,Shao G J.Study on the initial electro-deposition behav-ior of Ni-P alloy[J].J.Chin.Soc.Corros.Prot.,2004,24(1):6-9(秦秀娟,邵光杰.电沉积Ni-P合金初期沉积行为的研究[J].中国腐蚀与防护学报,2004,24(1):6-9)
[9]Feng L J,Ma X J,Lei A L.Corrosion resistance of electrolessplating Ni-P alloy coating in sulfur-bearing solution[J].J.Chin.Soc.Corros.Prot.,2006,26(3):157-159(冯拉俊,马小菊,雷阿利.含硫介质中化学镀Ni-P合金镀层耐蚀性研究[J].中国腐蚀与防护学报,2006,26(3):157-159)
[10]Li L B,An M Z,Wu G H.Corrosion resistance of electroless Nicoatings on SiCp/Al composite and mechanism[J].J.Chin.Soc.Corros.Prot.,2006,26(3):160-164(李丽波,安茂忠,武高辉.SiCp/Al复合材料化学镀镍层耐蚀性能及机理研究[J].中国腐蚀与防护学报,2006,26(3):160-164)
[11]Huo H W,Li Y,Wang F H.Electroless nickel plating on AZ91Dmagnesium alloy[J].J.Chin.Soc.Corros.Prot.,2002,22(1):14-17(霍宏伟,李瑛,王福会.AZ91D镁合金化学镀镍[J].中国腐蚀与防护学报,2002,22(1):14-17)
[1] 黎敏, 魏高飞, 邓书端, 李向红. 扫描电化学显微镜(SECM)在缓蚀剂研究中的进展与展望[J]. 中国腐蚀与防护学报, 2026, 46(5): 1326-1342.
[2] 谢敬礼, 王友志, 乔书振, 牛佳雨, 郝龙, 曹胜飞, 王俭秋. 高放废物地质处置库近场环境中碳钢腐蚀产物演化研究进展[J]. 中国腐蚀与防护学报, 2026, 46(5): 1343-1352.
[3] 周书宇, 刘昌璞, 杨留洋, 耿杰, 范海明, 张大磊, 鞠虹. 在超临界CO2 工况和典型环境因素共影响下的管线钢腐蚀及防护技术研究进展[J]. 中国腐蚀与防护学报, 2026, 46(5): 1353-1368.
[4] 黄绘, 李树丽, 邓书端, 李向红. 自修复材料在防护涂层中的研究进展及展望[J]. 中国腐蚀与防护学报, 2026, 46(5): 1369-1388.
[5] 曾崎, 虞文军, 门向南, 冯保净, 杨耀, 朱凯, 葛玉麟, 应韬, 曾小勤. 高强耐蚀稀土镁合金研究进展[J]. 中国腐蚀与防护学报, 2026, 46(5): 1415-1424.
[6] 张强, 卢壹梁, 金焱, 陈云, 杨丙坤, 王晓芳, 韩钰. 环境腐蚀性分级及大气/土壤腐蚀性地图绘制技术研究进展[J]. 中国腐蚀与防护学报, 2026, 46(5): 1425-1436.
[7] 许佳程, 刘家兵, 黄诗雨, 金灵好, 谭伟, 郭娜, 刘涛. 人工极地海域环境致EH40船板钢的力学性能损伤与应力腐蚀行为研究[J]. 中国腐蚀与防护学报, 2026, 46(5): 1437-1451.
[8] 郑凯, 王艺陶, 王东胜, 刘伟, 蒋颖畅, 黄嵘, 常雪婷. 腐蚀-应力耦合作用对极地船用螺旋桨低碳马氏体不锈钢失效机理影响研究[J]. 中国腐蚀与防护学报, 2026, 46(5): 1452-1462.
[9] 齐晓涵, 翟海民, 李文生, 洪昊, 曹元, 俞雷, 陈博瀚. Al2O3 磨加量对铝合金搪瓷涂层组织结构及腐蚀性能的影响[J]. 中国腐蚀与防护学报, 2026, 46(5): 1497-1507.
[10] 贾梦瑶, 张伟强, 王媛, 谭季波, 邱建科, 郝延天, 吴欣强. 在3.5%NaCl溶液中压力变化对Ti80合金应力腐蚀行为的影响[J]. 中国腐蚀与防护学报, 2026, 46(5): 1508-1516.
[11] 李晓峰, 李艳茹, 卢云飞, 张泰华, 常雪婷, 安燕. 力学与防腐性能协同增强的聚吡咯改性芳纶纤维/环氧复合涂料[J]. 中国腐蚀与防护学报, 2026, 46(5): 1517-1526.
[12] 曹天慧, 杨砚淇, 刘雨薇, 吴磊, 郭泉忠, 贾志刚, 曹公望, 汪川. 23MnNiMoCr54钢在不同pH的模拟高矿化水中腐蚀机理研究[J]. 中国腐蚀与防护学报, 2026, 46(5): 1537-1548.
[13] 赵先锐, 戴中国, 李战江, 徐育烺, 张会霞, 李旺. 添加Y、Hf对AlCoCrFeNi高熵合金涂层在NaCl溶液中的腐蚀行为的影响[J]. 中国腐蚀与防护学报, 2026, 46(5): 1549-1559.
[14] 王兴斌, 李家民, 伍登骏, 唐伟能, 杨静, 郭嘉成, 杨欣宇, 侯娟. Al含量对Mg-xAl-Zn合金耐腐蚀性能的影响[J]. 中国腐蚀与防护学报, 2026, 46(5): 1560-1568.
[15] 叶海锋, 沈书成, 陈江华. 增材制造316L不锈钢在不同温度海水环境中的腐蚀行为研究[J]. 中国腐蚀与防护学报, 2026, 46(5): 1569-1578.