Please wait a minute...
中国腐蚀与防护学报  2008, Vol. 28 Issue (1): 48-52     
  失效分析 本期目录 | 过刊浏览 |
高强度铝合金构件腐蚀疲劳失效分析
张正贵
沈阳大学机械工程学院材料科学系
Corrosion Fatigue Fracture Failure Analysis of High-strength Aluminum Alloy
ZHANG Zheng-gui
沈阳大学机械工程学院材料科学系
全文: PDF(1145 KB)  
摘要: 在应力作用下对带有涂层的高强度铝合金构件在3.5% NaCl溶液中腐蚀疲劳断口进行了研究。结果表明:在腐蚀条件下高强度铝合金构件断口上不仅出现疲劳辉纹,还出现准解理、解理、沿晶等断裂特征,腐蚀疲劳过程属于阳极溶解机制控制。失效形式为多裂纹断裂,在各个铆孔处均有裂纹萌生,其中有一处为主裂纹,其位置不固定,主裂纹扩展距离较长,最后与其它裂纹汇合,最终导致疲劳断裂。
关键词 铝合金构件腐蚀疲劳失效    
Abstract:The fractography of high strength aluminum alloy LY12CZ riveted specimen with coating was investi?鄄gated after corrosion fatigue tests under stress in 3.5% NaCl solution. Fracture features like fatigue striation, dimple, cleavage, and intergranular fracture were observed. The corrosion fatigue mechanism was controlled by anodic dissolution. The failure mode was multi-crack fracture. Cracks were initiated from every rivet holes. The principal crack with longer propagation length and varying positions finally converged with other cracks and led to fatigue fracture.
Key words
收稿日期: 2006-05-16     
通讯作者: 张正贵     E-mail: zhzgsy@163.com
Corresponding author: ZHANG Zheng-gui     E-mail: zhzgsy@163.com

引用本文:

张正贵 . 高强度铝合金构件腐蚀疲劳失效分析[J]. 中国腐蚀与防护学报, 2008, 28(1): 48-52 .
ZHANG Zheng-gui. Corrosion Fatigue Fracture Failure Analysis of High-strength Aluminum Alloy. J Chin Soc Corr Pro, 2008, 28(1): 48-52 .

链接本文:

https://www.jcscp.org/CN/      或      https://www.jcscp.org/CN/Y2008/V28/I1/48

[1]Parkings R N.Gangloff R P,Ives M B,ed.Environment-Induced Cracking of Metals[M].Houston,Tx:NACE,1990,1
[2]Zhang B,Zhang Z G,Han E H,Ke W,et al.Study of corrosion fatigue for LY12CZ aluminum alloy riveted lap-splice joints[J].Acta Metal.Sin.,2000,36(8):842-846(张波,张正贵,韩恩厚,柯伟等.LY12CZ铝合金铆接联接件在3.5%NaCl溶液中的腐蚀疲劳失效行为研究[J].金属学报,2000,36(8):842-846)
[3]Segerfrojd G,Blom A F.Fatigue behavior of mechanical joints:A state of the art overview[A].Proceedings of the Seventh International Fatigue Congress[C].Beijing,1999,1:41
[4]Newman J C,Jr,Harris C E,Piascik R S,Dawicke D S.Methodology for predicting the onset of widespread fatiguedamagein lap-splice joints and structure[A].Proceedings of the Seventh International Fatigue Congress[C].Beijing,1999,1:81
[5]Zhang B.The corrosion fatigue study on LY12CZ aluminum alloy and its rivet joint in sodium chloride solution[D].Shengyang:Institute of Metal Research,Chinese Academy of Sciences,2001(张波.LY12CZ铝合金及其铆接联接件在氯化钠溶液中的腐蚀疲劳研究[D].沈阳:中国科学院金属研究所,2001)
[6]Liu Y M,Jiang J L,Shan Y S.Some effects on fatigue properties under protection/unprotection coating systems[J].Acta Aeronautica et Astronautica Sinica,1998,19(4):481-485(刘一鸣,蒋军亮,山永寿.环境对有/无防护涂层结构疲劳性能的影响[J].航空学报.1998,19(4):481-485)
[7]Zhang Z G,Zhang B,Han E H,et al.Influence og stress amplitude and corrosive factors on corrosion fatigue life of riveted joints[J].J.Mechanical Strength,2001,23(2):243-245(张正贵,张波,韩恩厚等.应力与腐蚀因素对连接件腐蚀疲劳寿命交互作用的研究[J].机械强度,2001,23(2):243-245)
[8]Zhang Z G.The investigation of corrosion fatigue on riveted joiots[D].Shengyang:Northeastern University,2000(张正贵.连接件腐蚀疲劳性能的研究[D].沈阳:东北大学,2000)
[9]Liu Z M,Zeng F Y,Lu L J,et al.An effect of corrosion environment on fatigue properties of LY12CZ Al-Alloy typical bolted lap joints[J].J.Chin.Soc.Corros.Prot.,2004,24(5):267-271(刘祖铭,曾凡阳,鲁礼菊等.环境对LY12CZ铝合金典型螺接件疲劳性能的影响[J].中国腐蚀与防护学报,2004,24(5):267-271)
[10]Chang H,Han E H,Wang J Q,et al.Influence of coating of covering airplane on corrosion fatigue life of aluminum alloy LY12CZ[J].J.Chin.Soc.Corros.Prot.,2006,25(1):34-36(常红,韩恩厚,王俭秋等.飞机蒙皮涂层对LY12CZ铝合金腐蚀疲劳寿命的影响[J].中国腐蚀与防护学报,2006,25(1):34-36)
[11]Li D,Zhang Q,Wang D Z,et at.Study of the simulated test for the intergranular corrosion of LY12CZ Al alloy[J].J.BeijingUniversity of Aeronautics and Astronautics,1998,24(1):1-3(李荻,张琦,王弟珍等.LY12CZ铝合金晶间腐蚀模拟试验研究[J].北京航空航天大学学报,1998,24(1):1-3)
[12]Zhang D.The trace Analysis of Mechanical Failure[M].Beijing:Defense Industry Press,1996(张栋.机械失效的痕迹分析[M].北京:国防工业出版社,1996)
[13]Jiang Z G.Corrosion Fatigue of Airplane Structure[M].Beijing:Aviation Industry Press,1992(蒋祖国.飞机结构腐蚀疲劳[M].北京:航空工业出版社,1992)
[14]Wu Y S,Xie J H,Wang X Y,et at.Initiation mechanism of corrosion fatigue crack for stainless steel in chloride solution[J].Corros.Sci.Prot.Technol.,1999,11(1):24-31(吴荫顺,谢建辉,汪轩义等.氯化物溶液中不锈钢腐蚀疲劳裂纹初始萌生的过程机理[J].腐蚀科学与防护技术,1999,11(1):24-31)
[1] 张雨轩, 陈翠颖, 刘宏伟, 李伟华. 铝合金霉菌腐蚀研究进展[J]. 中国腐蚀与防护学报, 2021, 41(1): 13-21.
[2] 于宏飞, 邵博, 张悦, 杨延格. 2A12铝合金锆基转化膜的制备及性能研究[J]. 中国腐蚀与防护学报, 2021, 41(1): 101-109.
[3] 胡露露, 赵旭阳, 刘盼, 吴芳芳, 张鉴清, 冷文华, 曹发和. 交流电场与液膜厚度对A6082-T6铝合金腐蚀行为的影响[J]. 中国腐蚀与防护学报, 2020, 40(4): 342-350.
[4] 曹京宜, 方志刚, 陈晋辉, 陈志雄, 殷文昌, 杨延格, 张伟. 5083铝合金表面单致密微弧氧化膜的制备及其性能研究[J]. 中国腐蚀与防护学报, 2020, 40(3): 251-258.
[5] 王英君, 刘洪雷, 王国军, 董凯辉, 宋影伟, 倪丁瑞. 新型高强稀土Al-Zn-Mg-Cu-Sc铝合金的阳极氧化及其抗腐蚀性能研究[J]. 中国腐蚀与防护学报, 2020, 40(2): 131-138.
[6] 曹京宜, 王智峤, 李亮, 孟凡帝, 刘莉, 王福会. 深海压力交变加速条件下改性石墨烯有机涂层的失效机制[J]. 中国腐蚀与防护学报, 2020, 40(2): 139-145.
[7] 赵书彦,童鑫红,刘福春,翁金钰,韩恩厚,郦晓慧,杨林. 环氧富锌涂层防腐蚀性能研究[J]. 中国腐蚀与防护学报, 2019, 39(6): 563-570.
[8] 王贵容,郑宏鹏,蔡华洋,邵亚薇,王艳秋,孟国哲,刘斌. 环氧防腐涂料在模拟海水干湿交替条件下的失效过程[J]. 中国腐蚀与防护学报, 2019, 39(6): 571-580.
[9] 任建平,宋仁国. 双级时效对7050铝合金力学性能及氢脆敏感性的影响[J]. 中国腐蚀与防护学报, 2019, 39(4): 359-366.
[10] 夏俊捷,牛红志,刘敏,曹华珍,郑国渠,伍廉奎. 基于卤素效应的阳极氧化技术提高Ti48Al5Nb合金抗高温氧化性能[J]. 中国腐蚀与防护学报, 2019, 39(2): 96-105.
[11] 廖家鹏,吴欣强. 核电材料高温高压水缺口疲劳性能研究现状与进展[J]. 中国腐蚀与防护学报, 2018, 38(6): 511-516.
[12] 陈高红,胡远森,于美,刘建华,李国爱. 硫酸阳极化对2E12铝合金力学性能的影响[J]. 中国腐蚀与防护学报, 2018, 38(6): 579-586.
[13] 曹敏, 刘莉, 余钟芬, 李瑛, 王福会. 2A02铝合金在模拟海洋大气环境中的剥蚀行为研究[J]. 中国腐蚀与防护学报, 2018, 38(5): 502-510.
[14] 马景灵, 通帅, 任凤章, 王广欣, 李亚琼, 文九巴. L-半胱氨酸/ZnO缓蚀剂对3102铝合金在碱性溶液中电化学性能的影响[J]. 中国腐蚀与防护学报, 2018, 38(4): 351-357.
[15] 郝利新, 贾瑞灵, 张慧霞, 张伟, 赵婷, 翟熙伟. 7A52铝合金双丝MIG焊接头的不均匀性对其表面微弧氧化膜腐蚀防护作用的影响[J]. 中国腐蚀与防护学报, 2018, 38(3): 219-225.