Please wait a minute...
中国腐蚀与防护学报  2010, Vol. 30 Issue (4): 323-328    
  研究报告 本期目录 | 过刊浏览 |
不同冷却方式对热轧带钢氧化皮结构及其耐蚀性的影响
周贤良1,2,朱敏1,华小珍1,叶志国1,崔霞1,邹爱华1
1. 南昌航空大学材料科学与工程学院 南昌 330063
2. 南昌航空大学 无损检测教育部重点实验室 南昌 330063
INFLUENCE OF DIFFERENT COOLING METHODS ON CORROSION RESISTANCE OF OXIDE SCALE STRUCTURE OF HOT ROLLED STRIP
ZHOU Xianliang1,2, ZHU Min1, HUA Xiaozhen1,YE Zhiguo1, CUI Xia1, ZOU Aihua1
1. School of Materials Science and Engineering, Nanchang Hangkong University, Nanchang 330063
2. Key Laboratory of Nondestructive Test, Ministry of Education, Nanchang Hangkong University, Nanchang 330063
全文: PDF(1526 KB)  
摘要: 

利用不同冷却方式在SS400热轧带钢表面形成了不同结构的氧化皮,通过腐蚀形貌宏观观察、SEM、EDS、XRD、失重法、干湿周期浸润腐蚀加速实验和电化学方法对不同结构氧化皮的热轧带钢在NaHSO3溶液中腐蚀行为进行了研究。研究表明,不同冷却方式下所制热轧带钢的氧化皮均主要由Fe3O4组成,另含有Fe2O3和Fe。随着冷却速度的减小,氧化皮中Fe3O4的含量增加,但未发现有FeO;随炉冷却所制热轧带钢的氧化皮较厚且均匀,并存在分层现象(外层为Fe2O3,内层为Fe3O4+Fe),在NaHSO3溶液中耐蚀性最好;装罐冷却所制氧化皮较均匀平整,耐蚀性次之;自然空冷所制氧化皮存在着较多的缺陷,耐蚀性最差。

关键词 冷却方式氧化皮腐蚀行为耐蚀性    
Abstract

Different structures scales were formed on the surface of SS400 hot rolled strip with different cooling methods. Corrosion behaviors of hot rolled strip with different oxide scales were investigated in sodium bisulfite solution by SEM, EDS, XRD, accelerated cyclic wet-dry immersion corrosion test, polarization curves and electrochemical impedance spectroscopy (EIS). The results showed that three kinds of oxide scales prepared by different cooling methods mainly consisted of Fe3O4, as well as a spot of Fe2O3 and Fe. The content of Fe3O4 increased with cooling rate reducing, but FeO was not detected. Oxide scale prepared by furnace cooling on the strip consisted of the outer Fe2O3 layer and the inner Fe3O4+Fe layer, and its thickness was more thick and homogeneous than the rest scales. Oxide scale prepared by jar cooling was homogeneous, but that prepared by air cooling had a lot of defects. Corrosion resistance of strip prepared by furnace cooling was best in 0.01 mol/L sodium bisulfite solution, but that of strip prepared by air cooling was worst.

Key wordscooling method    oxide scale    corrosion behavior    corrosion resistance
收稿日期: 2009-06-10     
ZTFLH: 

TG172.3

 
基金资助:

国家自然科学基金项目(50871051)、教育部无损检测重点实验室基金项目(ZD200729003)、江西省教育厅重点实验室基金项目(DB200901399)及江西省自然科学基金项目(2009GZC5009)资助}

通讯作者: 周贤良     E-mail: zmii2009@163. com
作者简介: 周贤良,男,1957年生,教授,研究方向为钢铁高温氧化、大气腐蚀及金属基复合材料

引用本文:

周贤良,朱敏,华小珍,叶志国,崔霞,邹爱华. 不同冷却方式对热轧带钢氧化皮结构及其耐蚀性的影响[J]. 中国腐蚀与防护学报, 2010, 30(4): 323-328.
ZHOU Xian-Liang, ZHU Min. INFLUENCE OF DIFFERENT COOLING METHODS ON CORROSION RESISTANCE OF OXIDE SCALE STRUCTURE OF HOT ROLLED STRIP. J Chin Soc Corr Pro, 2010, 30(4): 323-328.

链接本文:

https://www.jcscp.org/CN/      或      https://www.jcscp.org/CN/Y2010/V30/I4/323

[1] Uyulgan B, Dokumaci E, Celik E, et al. Wear behaviour of thermal flame sprayed FeCr coatings on plain carbon steel substrate [J]. J. Mater. Process. Technol., 2007,190(1/3): 204-210 [2] Beverskog B, Bojinov M, Englund A, et al. A mixed-conduction model for oxide films on Fe, Cr and Fe-Cr alloys in high-temperature aqueous electrolytes-I. Comparison of the electrochemical behavior at room temperature and at 200℃ [J].Corros. Sci., 2002, 44: 1901-1921 [3] Kurokawa H, Kawamura K,Maruyama T. Oxidation behavior of Fe-16Cr alloy interconnect for SOFC under hydrogen potential gradient [J]. Solid State Ionics,2004, 168: 13-21 [4] Ostwald R, Grabke H J. Initial oxidation andchromium diffusion I. Efeects of surface working on 9-20%Cr steels [J]. Corros. Sci., 2004, 46: 1113-1127 [5] Zhang Z Y, Wang Z P, Liang B, et al. Effects of CeO2 on friction and wear characteristics of Fe-Ni-Cr alloy coatings [J]. Tribol.Int., 2006, 39: 971-978 [6] Maier N, Nickel K G, Rixecker G. High temperature water vapour corrosion of rare earth disilicates (Y,Yb,Lu)2Si2O7 in the presence of Al(OH)3 impurities [J]. J. Eur.Ceram. Soc., 2007, 27: 2705-2713 [7] Zeng C L, Rizzo F C, Wu W T, et al. The oxidation of Co-Y binary alloys at 600~800℃ in air [J]. Corros. Sci., 1999, 41: 1731-1736 [8] Rada M, Gebert A, Mazilu I, et al. Corrosion studies on highly textured Nd-Fe-B sintered magnets [J]. J. Alloys Compd., 2006, 415: 111-120 [9] Fernandes S M C, Ramanathan L V. Influence of rare earth oxide coatings on oxidation behavior of Fe-20Cr alloys [J]. Surf. Eng., 2000,l6(4): 327-332 [10] Pan J, Leygraf C, Jargelius-Pettersso R F A, et al. Characterization of high-temperature oxide films on stainless steels by electrochemical impedance spectroscopy [J]. Oxid. Met., 1998, 50(5-6): 431-455 [11] lshikawa S, Masaaki K, Chizuko M. Grain-boundary segregation of La and Zr in alumina scales formed on Fe-20 mass%Cr-5 mass%Al alloys [J]. J. Jpn. Inst. Met.,l996, 60(5): 463-468 [12] Mennicke C, Schumann E, Ruhle M. The effect of yttrium on the growth process and microstructure of α-Al2O3 on FeCrAl [J]. Oxid. Met., 1998, 49(5-6): 455-466
[1] 黄鹏, 高荣杰, 刘文斌, 尹续保. 盐溶液刻蚀-氟化处理制备X65管线钢镀镍超双疏表面及其耐蚀性研究[J]. 中国腐蚀与防护学报, 2021, 41(1): 96-100.
[2] 包任, 周根树, 李宏伟. 恒电位脉冲电沉积高锡青铜耐蚀镀层工艺研究[J]. 中国腐蚀与防护学报, 2020, 40(6): 585-591.
[3] 李琳, 陈义庆, 高鹏, 艾芳芳, 钟彬, 伞宏宇, 杨颖. 除冰盐环境下桥梁钢的耐腐蚀性能研究[J]. 中国腐蚀与防护学报, 2020, 40(5): 448-454.
[4] 刘海霞, 黄峰, 袁玮, 胡骞, 刘静. 690 MPa级高强贝氏体钢在模拟乡村大气中的腐蚀行为[J]. 中国腐蚀与防护学报, 2020, 40(5): 416-424.
[5] 李聪玮, 杜双明, 曾志琳, 刘二勇, 王飞虎, 马付良. 电流密度对Ni-Co-B镀层微观结构及磨蚀性能的影响[J]. 中国腐蚀与防护学报, 2020, 40(5): 439-447.
[6] 张欣, 杨光恒, 王泽华, 曹静, 邵佳, 周泽华. 冷拉拔变形过程中含稀土铝镁合金腐蚀行为研究[J]. 中国腐蚀与防护学报, 2020, 40(5): 432-438.
[7] 胡露露, 赵旭阳, 刘盼, 吴芳芳, 张鉴清, 冷文华, 曹发和. 交流电场与液膜厚度对A6082-T6铝合金腐蚀行为的影响[J]. 中国腐蚀与防护学报, 2020, 40(4): 342-350.
[8] 曹京宜, 方志刚, 陈晋辉, 陈志雄, 殷文昌, 杨延格, 张伟. 5083铝合金表面单致密微弧氧化膜的制备及其性能研究[J]. 中国腐蚀与防护学报, 2020, 40(3): 251-258.
[9] 王新华, 杨永, 陈迎春, 位凯玲. 交流电流对X100管线钢在库尔勒土壤模拟液中腐蚀行为的影响[J]. 中国腐蚀与防护学报, 2020, 40(3): 259-265.
[10] 王英君, 刘洪雷, 王国军, 董凯辉, 宋影伟, 倪丁瑞. 新型高强稀土Al-Zn-Mg-Cu-Sc铝合金的阳极氧化及其抗腐蚀性能研究[J]. 中国腐蚀与防护学报, 2020, 40(2): 131-138.
[11] 胡玉婷, 董鹏飞, 蒋立, 肖葵, 董超芳, 吴俊升, 李晓刚. 海洋大气环境下TC4钛合金与316L不锈钢铆接件腐蚀行为研究[J]. 中国腐蚀与防护学报, 2020, 40(2): 167-174.
[12] 张尧, 郭晨, 刘妍慧, 郝美娟, 成世明, 程伟丽. 挤压态Mg-2Sn-1Al-1Zn合金在模拟体液中的电化学腐蚀行为[J]. 中国腐蚀与防护学报, 2020, 40(2): 146-150.
[13] 范益,陈林恒,蔡佳兴,代芹芹,马宏驰,程学群. 热轧AH36船板钢在室内仓储条件下的腐蚀行为研究[J]. 中国腐蚀与防护学报, 2020, 40(1): 10-16.
[14] 王乐,易丹青,刘会群,蒋龙,冯春. Ru对Ti-6Al-4V合金腐蚀行为的影响及机理研究[J]. 中国腐蚀与防护学报, 2020, 40(1): 25-30.
[15] 武栋才,韩培德. 中温时效处理对SAF2304双相不锈钢耐蚀性的影响[J]. 中国腐蚀与防护学报, 2020, 40(1): 51-56.