Please wait a minute...
中国腐蚀与防护学报  2009, Vol. 29 Issue (6): 411-414         
  研究报告 本期目录 | 过刊浏览 |
改性纳米SiC粉体强化铸造奥氏体不锈钢耐点蚀性能的研究
陈美玲;刘元栋;杨莉;杨军;高宏
大连交通大学材料科学与工程学院 大连 116028
PITTING CORROSION RESISTANCE OF NANO-SiC POWDERS REINFORCED CAST STAINLESS STEEL
CHEN Meiling; LIU Yuandong; YANG Li; YANG Jun; GAO Hong
School of Materials Science and Engineering; Dalian Jiaotong University; Dalian 116028
引用本文:

陈美玲 刘元栋 杨莉 杨军 高宏. 改性纳米SiC粉体强化铸造奥氏体不锈钢耐点蚀性能的研究[J]. 中国腐蚀与防护学报, 2009, 29(6): 411-414.
, , , , . PITTING CORROSION RESISTANCE OF NANO-SiC POWDERS REINFORCED CAST STAINLESS STEEL[J]. J Chin Soc Corr Pro, 2009, 29(6): 411-414.

全文: PDF(1042 KB)  
摘要: 

在生产条件下采用冲入法制备了改性纳米SiC粉体强化奥氏体不锈钢试样,用化学浸泡和电化学检测两种方法研究了纳米SiC粉体对不锈钢耐点蚀性能的影响。结果表明,经改性纳米SiC粉体强化处理后的不锈钢组织明显细化,成分偏析引起的铁素体析出减少;当纳米SiC粉体加入量为0.1 mass%时,不锈钢的点蚀速率降低了 16%,电极电位提高了3倍。能谱分析表明,经强化处理,不锈钢中的Cr成分偏析减轻,有效改善了晶界等易发生点蚀部位的贫Cr现象。

关键词 : 改性纳米SiC粉体,  奥氏体不锈钢,  显微组织,  点蚀    
Abstract:

Cast austenitic stainless steels reinforced by modified SiC nano-powders have been prepared with pour over process under industrial conditions, and the effect of modified SiC nano-powders on the pitting corrosion resistance of the austenitic stainless steel was characterized by pitting chemistry immersion and pitting electrochemistry tests, metallographic analysis, SEM and energy dispersive analysis. The results showed that, compared with the samples without SiC nano-powders, the reinforced stainless steel was characterized with finer microstructure, and less ferrite precipitation owing to composition segregational the pitting corrosion velocity had decreased by 16% and the electric potential increased by three times respectively when the content of nano-SiC rose to 0.1 mass%. Furthermore, the results of energy dispersive analysis of samples with the scanning electron microscopy revealed that the Cr segregation in the reinforced austenitic stainless steels reduced, and the Cr depletion in such zones sensitive to pitting corrosion as grain boundaries has been improved.

Key words: modified SiC nano-powders    cast austenitic stainless steel    microstructure    pitting corrosion
收稿日期: 2008-04-11     
ZTFLH: 

TG174.3

 
基金资助:

辽宁省教育厅计划项目(05L038)资助

作者简介: 陈美玲,女,1960年生,教授,研究方向为铸造合金

[1] Qin L Y, Zhang S L, Song S Z. Sensitive temperatures for intergranular corrosion of typical stainless steels [J]. J. Chin. Soc. Corros. Prot., 2006, 26(1): 1-5
    (秦丽雁,张寿禄,宋诗哲. 典型不锈钢晶间腐蚀敏化温度的研究 [J]. 中国腐蚀与防护学报,2006, 26(1): 1-5)
[2] Taboda A, Prank L. Intergranular Corrosion in Nuclear System, Intergranular Corrosion in Stainless Alloys [M]. ASTM STP 656. Steigerwald R F, ed. Philadelphia, PA: ASTM, 1978,85
[3] Liu Q Y, Hou H Y. Controlled rolling of microalloyed steels for ultrafine ferrite [J]. J. Iron Steel Res., 2000, 12(6): 29-32
    (刘清友,侯豁然. 微合金钢超细组织的控制轧制 [J]. 钢铁研究学报,2000,12(6):29-32)
[4] Chen M L, Li J W, Gao H. Research on the microstructure and mechanical properties of surface modified SiC nanometer powders reinforced nodular cast iron [J]. Mater. Rev., 2006, 20(5): 214-215
    (陈美玲,李建卫,高宏. 改性纳米SiC粉体强化球墨铸铁的组织和力学性能的研究 [J]. 材料导报, 2006,20 (5): 214-215)
[5] Li J W, Chen M L, Gao H. Research on the wear resistance of surface modified SiC nano-powders reinforced gray cast iron [J]. Foundry, 2007, 26(1): 68-70
    (李建卫,陈美玲,高宏. 改性纳米SiC粉体强化灰铸铁耐磨性能的研究 [J]. 铸造, 2007, 26(1): 68-70)
[6] Hu D C. Metal Structures and Anticorrosion [M].Beijing:China Astronautic Publishing House, 1987
    (胡德昌. 金属结构与抗蚀 [M]. 北京:宇航出版社,1987)
[7] Yue R, Pan Z J, Li Y. Corrosion analysis for stainless steel [J]. Met. World, 2006, 3: 28-29  
    (岳睿,潘祖军,李艳. 不锈钢的腐蚀分析 [J]. 金属世界, 2006,3: 28-29)
[8] Zhang D K. Local Corrosion of Stainless Steel [M]. Beijing: Science Press, 1982
    (张德康. 不锈钢局部腐蚀 [M]. 北京:科学出版社,1982)
[9] Gu X H. Common corrosion and protection of austenite stainless steel [J]. Jiangxi Chem. Ind., 2006, 4: 220-221
    (古晓辉. 奥氏体不锈钢的常见腐蚀及避免措施 [J]. 江西化工, 2006,4:220-221)
[10] Sun Q X. Corrosion and Protection for Materials [M]. Beijing:Metallurgical Industry Press, 2001
     (孙秋霞. 材料腐蚀与防护 [M]. 北京:冶金工业出版社. 2001)

[1] 陆海峰, 缪强, 梁文萍, 姚志猛, 魏少翀, 陈国星. 激光清洗对不锈钢表面耐腐蚀性能的影响[J]. 中国腐蚀与防护学报, 2026, 46(4): 1227-1237.
[2] 张新瑞, 薛宝权, 谭季波, 张兹瑜, 高军, 吴欣强. 含铝奥氏体不锈钢液态铅铋环境相容性研究进展[J]. 中国腐蚀与防护学报, 2026, 46(3): 671-679.
[3] 兰博韬, 吴斌, 明洪亮, 王俭秋, 韩恩厚. 选区激光熔化奥氏体不锈钢高温高压水中应力腐蚀开裂行为研究进展[J]. 中国腐蚀与防护学报, 2026, 46(1): 1-14.
[4] 谷清宇, 宋雁飞, 张亮亮, 王楠, 雷晓维. 激光定向能量沉积17-4PH不锈钢钝化与点蚀行为研究[J]. 中国腐蚀与防护学报, 2026, 46(1): 103-114.
[5] 何燕, 刘燕, 田华, 陈晔. 低温扩散预处理对含B超级奥氏体不锈钢S31254析出相及耐蚀性的影响[J]. 中国腐蚀与防护学报, 2025, 45(6): 1773-1778.
[6] 佟向瑜, 徐玮辰, 王秀通, 王优强, 段继周. 常用钛合金焊接接头显微组织结构及对材料性能的影响[J]. 中国腐蚀与防护学报, 2025, 45(5): 1161-1174.
[7] 何武豪, 刘阳, 杨思懿, 张韶栋, 吴伟, 张俊喜. 敏化处理对传统和增材制造316L不锈钢电化学和晶间腐蚀的影响[J]. 中国腐蚀与防护学报, 2025, 45(5): 1331-1340.
[8] 张慧云, 郑留伟, 梁伟. 退火工艺对304奥氏体不锈钢的组织演变及氢脆行为的影响[J]. 中国腐蚀与防护学报, 2025, 45(2): 438-448.
[9] 燕冰川, 曾云鹏, 张宁, 史显波, 严伟. 石油管材用含Cu钢焊接接头的微生物腐蚀研究[J]. 中国腐蚀与防护学报, 2025, 45(2): 479-488.
[10] 马晋遥, 董楠, 郭振森, 韩培德. B、Ce微合金化对S31254超级奥氏体不锈钢析出相及耐蚀性能的影响[J]. 中国腐蚀与防护学报, 2024, 44(6): 1610-1616.
[11] 洪孝木, 王永强, 李娜, 田凯, 杜娟. 时效处理对马氏体时效硬化不锈钢显微组织和局部腐蚀性能的影响[J]. 中国腐蚀与防护学报, 2024, 44(5): 1285-1294.
[12] 赵骞, 张洁, 毛锐锐, 缪春辉, 卞亚飞, 滕越, 汤文明. Q235钢结构件表面热镀锌层的应力腐蚀及其机理[J]. 中国腐蚀与防护学报, 2024, 44(5): 1305-1315.
[13] 杨成, 杨广明, 王建军, 苗学良, 张译, 孙宝壮, 刘智勇. 温度对核电站用42CrMoE低合金钢在硼酸模拟液中腐蚀行为的影响[J]. 中国腐蚀与防护学报, 2024, 44(5): 1345-1352.
[14] 朱慧文, 郑黎, 张昊, 于宝义, 崔志博. Be对WE43镁合金高温氧化行为及阻燃性的影响[J]. 中国腐蚀与防护学报, 2024, 44(4): 1022-1028.
[15] 麻衡, 田会云, 刘宇茜, 王月香, 何康, 崔中雨, 崔洪芝. S420海工钢在不同海洋区带环境下的腐蚀行为研究[J]. 中国腐蚀与防护学报, 2024, 44(3): 635-644.