Please wait a minute...
中国腐蚀与防护学报  2007, Vol. 27 Issue (6): 354-362          
  研究报告 本期目录 | 过刊浏览 |
环境对高强度铝合金应力腐蚀行为的影响
张晓云
北京航空材料研究院
The Influence of Different Enviroments on Stress Corrosion Cracking
北京航空材料研究院
引用本文:

张晓云 . 环境对高强度铝合金应力腐蚀行为的影响[J]. 中国腐蚀与防护学报, 2007, 27(6): 354-362 .

全文: PDF(654 KB)  
摘要: 本文研究了高强度铝合金在大气环境下的应力腐蚀性能,并与实验室加速试验结果进行对比。2A12和 7A04 铝合金的C型环应力腐蚀试样分别取自直径为30mm和40mm的棒材的短横向,直拉伸应力腐蚀试样取相同规格与热处理条件的棒材的长向,施加的应力分别为60%σ0.2、70%σ0.2、80%σ0.2和90%σ0.2。所有带力试样暴露在北京大气试验站、青岛团岛大气试验站、海南万宁试验站,同时在实验室进行了3%NaCl溶液中周期浸润腐蚀试验和3%NaCl+0.5%H2O2溶液中的拉伸应力腐蚀试验。试验结果表明高强度铝合金在不同的环境中产生应力腐蚀的敏感性不同,在海洋性环境下2A12铝合金的应力腐蚀的敏感性比7A04高,在暴露期间未开裂的2A12铝合金C环试样则产生严重的剥落腐蚀,未开裂的7A04铝合金C环试样则产生严重的点腐蚀。3%NaCl溶液中周期浸润腐蚀试验和3%NaCl+0.5%H2O2溶液中的拉伸应力腐蚀试验作为高强铝合金SCC敏感性判定方法,模拟海洋大气腐蚀过程,与户外的试验结果具有较好的相关性。
关键词 : 海洋环境,  大气腐蚀,  加速试验,  应力腐蚀    
Abstract:An investigation of the stress corrosion cracking resistance of high strength aluminum alloys 2A12 and 7A04 in different atmospheric environment were presented, results were compared with those obtained in laboratory accelerated tests. C-ring and direct tension stress corrosion specimens were taken from the short transverse grain and the longitudinal direction of aluminum alloy stick respectively, applied stress level were 60, 70, 80 and 90 percent of the σ0.2. The atmospheric stress corrosion tests were exposed to three different atmospheric test stations in China, one in Beijing, typical semi-rural atmosphere, others in coastal city, Qingdao (East of China) and Wanning (South of China). In the meantime, alternate immersion and direct tension stress corrosion immersion in salt solution were conducted in laboratory condition. The results showed that SCC performance of aluminum alloys could be evaluated within one year in marine atmospheric environment, otherwise, only exfoliation corrosion or pitting was observed. The alternate corrosion results showed that SCC of aluminum alloy was consistent with outdoor exposed samples in the marine atmospheric environment.
Key words: Marine enviroments    atmospheric corrosion    accelerated tests    SCC
收稿日期: 2006-11-06     
ZTFLH:  TG172  
[1]Edited by R.Winston Revie.Uhlig′s Corrosion Handbook,Second Edition[M].NewYork:John Wiley & Sons,Inc,2000
[2]TSAI T C,Chuang T H.Atmospheric stress corrosion cracking of asuperplastic 7475 aluminum alloy[J].Metall.Mater.Trans.A,1996,27A(9)2617-2627
[3]Schra L,Hart W G J.Long-term outdoor stress corrosion testing ofoveraged 7000 series aluminum alloys[A].NLR TR 88012U[C].American,1988
[4]Humphries T S,Nelson E E.Seacoast stress corrosion cracking ofaluminum alloys[A].NASA TM-82393[C].American,1981
[5]Schra L,Faber J.Influence of environments on constant displace-ment stress corrosion crack growth in high strength aluminum al-loys[A].N83-23446[C].American,1981
[6]Liu J H,Li D,Guo B L.Investigation of stress corrosion crackingof 7xxx series aluminum alloys[J].Corros.Sci.Prot.Technol.,2001,13(4):218-221(刘继华,李荻,郭宝兰.7XXX系列Al合金应力腐蚀开裂研究[J].腐蚀科学与防护技术,2001,13(4):218-221)
[7]Shen H J,Guo W L,Lu G Z.Stress corrosion cracking suscepti-bility of aluminum alloys LC9 in Na Cl solution[J].Corros.Prot.,2002,23(5):190-201(沈海军,郭万林,吕国志.Na Cl溶液中LC9铝合金应力腐蚀特性的试验研究[J].腐蚀与防护,2002,23(5):190-201)
[8]Wang Y,Wang Z H,Fu Z L,et al.Effect of scandium on the stresscorrosion cracking and exfoliation corrosion of Al-Mg alloys[J].J.Chin.Soc.Corros.Prot,2005,25(4):218-221(王月,王政红,付自来等.含钪Al-Mg合金抗应力腐蚀和剥落腐蚀性能影响[J].中国腐蚀与防护学报,2005,25(4):218-221)
[9]Sun Z H,Liu M H,Zhang X Y,et al.Effect of tempered condi-tion on the stress corrosion cracking of Al-Zn-Mg-Cu alloys[J].J.Chin.Soc.Corros.Prot,2006,26(4):232-236(孙志华,刘明辉,张晓云等.时效制度对Al-Zn-Mg-Cu铝合金应力腐蚀敏感性的影响[J].中国腐蚀与防护学报,2006,26(4):232-236)
[10]Zhang X Y,Guo Y H,Tao C H,et al.Study on the desk-top springtype stress corrosion cracking testing machine[J].Equip.Environ.Eng.,2004,1(2):18-22(张晓云,郭玉海,陶春虎等.便携式拉伸应力腐蚀试验器的研制[J].装备环境工程,2004,1(2):18-22)
[11]Desk-Top Spring Type Stress Corrosion Cracking Testing Machine[P].China,ZL 022941339,2002(便携式拉伸应力腐蚀试验装置[P].中国,ZL 022941339,2002)
[1] 许佳程, 刘家兵, 黄诗雨, 金灵好, 谭伟, 郭娜, 刘涛. 人工极地海域环境致EH40船板钢的力学性能损伤与应力腐蚀行为研究[J]. 中国腐蚀与防护学报, 2026, 46(5): 1437-1451.
[2] 贾梦瑶, 张伟强, 王媛, 谭季波, 邱建科, 郝延天, 吴欣强. 在3.5%NaCl溶液中压力变化对Ti80合金应力腐蚀行为的影响[J]. 中国腐蚀与防护学报, 2026, 46(5): 1508-1516.
[3] 庞成泽, 邢少华, 杜敏, 徐铖. 海洋环境下铝合金腐蚀磨损研究进展[J]. 中国腐蚀与防护学报, 2026, 46(4): 962-970.
[4] 徐秋发, 郭岳, 刘骏, 杨东, 崔宇. 静水压力对铸造与锻造Ti-6Al-4V合金应力腐蚀的影响差异研究[J]. 中国腐蚀与防护学报, 2026, 46(4): 1031-1044.
[5] 王磊, 陶泽宇, 刘锋, 匡文军, 马鑫, 姚尧, 张国威. 水化学工况对四代核电直流蒸汽发生器用T22钢应力腐蚀开裂行为的影响[J]. 中国腐蚀与防护学报, 2026, 46(4): 1067-1080.
[6] 陆海峰, 缪强, 梁文萍, 姚志猛, 魏少翀, 陈国星. 激光清洗对不锈钢表面耐腐蚀性能的影响[J]. 中国腐蚀与防护学报, 2026, 46(4): 1227-1237.
[7] 李亮, 殷文昌, 郜阿旺, 韩小乐, 杨延格. 寒带海洋环境下金属材料腐蚀与防护研究进展[J]. 中国腐蚀与防护学报, 2026, 46(3): 629-640.
[8] 王萌萌, 曹国民, 孟繁兴, 李天亮, 宋沁峰, 单太航, 董亮. 混凝土配重层对近海海底钢质管道阴极保护效果的影响[J]. 中国腐蚀与防护学报, 2026, 46(3): 680-692.
[9] 谢睿, 蒋全通, 韩东晓, 陈烨, 刘万鹏, 裴炎彤, 段继周, 侯保荣. Al-10%RE (RE = Ce、Nd、Y、La)合金在典型海洋大气环境下的腐蚀行为研究[J]. 中国腐蚀与防护学报, 2026, 46(2): 365-380.
[10] 陈旭, 杨浩, 田一晨, 张国庆, 宋博, 王岐山, 肖成灿. D36低碳钢在不同模拟海洋环境中初期腐蚀行为研究[J]. 中国腐蚀与防护学报, 2026, 46(2): 549-557.
[11] 韩宇, 徐松, 华思然, 赵鹏, 王晓杰, 夏晓健, 张俊喜. 热镀锌层合金相的耐蚀性差异研究[J]. 中国腐蚀与防护学报, 2026, 46(2): 558-566.
[12] 兰博韬, 吴斌, 明洪亮, 王俭秋, 韩恩厚. 选区激光熔化奥氏体不锈钢高温高压水中应力腐蚀开裂行为研究进展[J]. 中国腐蚀与防护学报, 2026, 46(1): 1-14.
[13] 戴念维, 窦欣懿, 刘华剑, 冷滨. 增材制造合金在核能领域应用中的腐蚀研究进展[J]. 中国腐蚀与防护学报, 2026, 46(1): 15-24.
[14] 张泽群, 骆鑫杰, 刘鹏飞, 董凯, 卓先勤, 吴俊升, 张博威. TiC颗粒对激光粉末床熔融Al-Mg-Sc-Zr合金的微观结构与腐蚀行为的影响[J]. 中国腐蚀与防护学报, 2026, 46(1): 92-102.
[15] 岳远广, 尹志彪, 张子月, 江社明, 张启富. 一种大气腐蚀实时监测装置的开发及其在不同环境中的应用[J]. 中国腐蚀与防护学报, 2026, 46(1): 308-314.