Please wait a minute...
中国腐蚀与防护学报  1996, Vol. 16 Issue (3): 170-174         
  研究报告 本期目录 | 过刊浏览 |
核电钢A508的腐蚀疲劳研究
王正;贺菁;任晨星
郑州工学院
CORROSION FATIGUE OF REACTOR PRESSURE VESSEL STEEL A508 IN DISTILLED WATER
WANG Zheng;HE Jing;REN Chenxing (Zhengzhou Institute of Technology)
引用本文:

王正;贺菁;任晨星. 核电钢A508的腐蚀疲劳研究[J]. 中国腐蚀与防护学报, 1996, 16(3): 170-174.
, , . CORROSION FATIGUE OF REACTOR PRESSURE VESSEL STEEL A508 IN DISTILLED WATER[J]. J Chin Soc Corr Pro, 1996, 16(3): 170-174.

全文: PDF(1169 KB)  
摘要: 在位移可控的悬臂梁弯曲疲劳试验机上,对核电钢A508在20~80℃蒸馏水中的腐蚀疲劳特性进行了初步探讨,并结合电化学和断口分析,对其裂缝扩展机制进行了研究。结果表明,A508钢在蒸馏水中的裂缝扩展速率比在空气中的快4~6倍。在所研究的范围内,其da/dN随温度上升而下降。这与温度升高,水中的溶解氧量降低,腐蚀电位下降,钝化膜中的Fe2O3比例减少正好相对应;也与温度升高,断口中的沿晶断裂百分比下降完全吻合。在试验范围内,A508不会发生应力腐蚀开裂,属真腐蚀疲劳,其裂缝扩展由阳极溶解和纯疲劳断裂两个因素共同制约。最可能的模型是:在裂缝前沿,首先在某些局部微区发生侵蚀,这些微区之间便形成韧带,承受较高的有效应力强度因子幅值△Keff,从而导致机械撕裂。而这些韧带的断裂过程,控制着腐蚀疲劳的扩展。将实验结果与据此提出和韧带模型△Keff=△Kapp/(1-αC)的估算值进行比较,两者十分吻合。
关键词 : 核电钢A508,  腐蚀疲劳,  韧带模型    
Abstract:The behavior and mechanism of corrosion fatigue for A508 steel in distilled water were stydied by means of a displacement controlled cantilever bend fatigue machine as well as by fractographic and eledtrochemical techniques. The fatigue tests were performed at R=0, f=0.5Hz in ambient air distilled water at various temperatures. It was showed that the fatigue crack growth rates of A508 steel in distilled water were 4 to 6 times faster than that in ambient air, and that they decreased with increase in water temperature at 15-80℃. This was precisely related to the reduction of dissolved oxygen contents, corrosion potential and quantity of Fe2O3 in oxide film, and this agreed closely with the decrease in percentage of I.G. fracture with increasing water temperature. According to these data, it was suggested that the fatigue of A508 steel in distilled water should be considered as a true corrosion fatigue since no stress corrosion cracking occured and that the crack propagation might be controlled by anodic dissolution and simple fatigue rupture. A possible model was proposed in that local attacks occured,at the fracture front and the ligaments between these areas experienced a higher effective △K, resulting in mechanical rupture. The measured data were in reasonable agreement with the predicted curves of da/dN ~△k from this ligament model, △keff = △Kapp/(1-αC).
Key words: Reactor pressure vessel steel    Distilled water    Corrosion fatigue    Ligament model
收稿日期: 1996-06-25     
1NcikelRW,压力容器技术进展-1,缺陷分析.北京:机械工业出版社,19912McHenryHI,PenseAW.FatiguteCrackPropagationinSteelAlloyatElevatedTemperatures.ASTM,STP520;345~354,Philadelphia,19733CampbellJE,GerberichWW.断裂力学在选材方面的应用.北京:冶金工业出版社,19924KondoT,Kikuyanma.CorrosionFatigueofASTMA302BSteelinHighTemperatureWater,TheSimulatedNuclearReactorEnvironment,CorrosionFatigue:ChemistryMechanicsandMicrostructure.NACE-2,1971.5395NagataN.EnvironmentallyAssistedCrackingofStructuralMaterialsforLightWaterReactors.NRIMSpecialReport,TOkyo,19946KiesJA,etal.ASTM,SPT381,1965:3287H.克舍.金属腐蚀.北京:化学工业出版社,19848王正,张振宇,任晨星.中国腐蚀与防护学报,1994:14(1):439CongletonJ,ShojiT,ParknisRN.Corr.Sci.,1985,25:63310王正,王志奇.中国腐蚀与防护学报,1996,16(3):161.
[1] 刘夏城, 邹建荣, 高良文, 周龙, 谭季波, 吴欣强, 张兹瑜. 压水堆核电站不锈钢焊缝材料腐蚀疲劳模型[J]. 中国腐蚀与防护学报, 2026, 46(5): 1613-1618.
[2] 史轩铭, 谭季波, 张兹瑜, 吴欣强. 铅冷快堆候选结构材料液态铅铋共晶环境中疲劳行为研究进展[J]. 中国腐蚀与防护学报, 2025, 45(5): 1187-1195.
[3] 赵连红, 王英芹, 刘元海, 何卫平, 王浩伟. 四种飞机起落架用钢在模拟海水中的腐蚀行为研究[J]. 中国腐蚀与防护学报, 2024, 44(5): 1263-1273.
[4] 何训, 吴梦雪, 尹力, 朱金. 风-车流耦合作用下悬索桥吊索钢丝的双蚀坑损伤演化及疲劳寿命研究[J]. 中国腐蚀与防护学报, 2023, 43(6): 1358-1366.
[5] 陈震宇, 朱忠亮, 马辰昊, 张乃强, 刘宇桐. 加载条件对镍基617合金在超临界水中腐蚀疲劳裂纹扩展速率的影响[J]. 中国腐蚀与防护学报, 2023, 43(5): 1057-1063.
[6] 刘冬, 刘静, 黄峰, 杜丽影. 海洋工程结构用钢服役环境模拟及DH36钢腐蚀疲劳裂纹扩展性能研究[J]. 中国腐蚀与防护学报, 2022, 42(6): 959-965.
[7] 王歧山, 李鸿瑾, 何川, 郑平, 陈旭. 加载波形对X65钢腐蚀疲劳裂纹萌生及扩展的影响[J]. 中国腐蚀与防护学报, 2022, 42(2): 227-234.
[8] 张兹瑜, 吴欣强, 韩恩厚, 柯伟. 核电结构材料腐蚀疲劳裂纹扩展行为研究现状与进展[J]. 中国腐蚀与防护学报, 2022, 42(1): 9-15.
[9] 孙晓光, 王子晗, 徐学旭, 韩晓辉, 李刚卿, 刘智勇. 工业大气环境对Al-Mg-Si合金腐蚀疲劳特性的影响[J]. 中国腐蚀与防护学报, 2021, 41(4): 501-507.
[10] 廖家鹏,吴欣强. 核电材料高温高压水缺口疲劳性能研究现状与进展[J]. 中国腐蚀与防护学报, 2018, 38(6): 511-516.
[11] 刘晓强,徐雪莲,谭季波,王媛,吴欣强,郑宇礼,孟凡江,韩恩厚. 反应堆冷却剂环境对690合金传热管疲劳性能影响研究[J]. 中国腐蚀与防护学报, 2015, 35(3): 213-219.
[12] 梁瑞, 张新燕, 李淑欣, 姜峰, 陈帅甫. 半椭球蚀坑对圆棒应力集中的影响[J]. 中国腐蚀与防护学报, 2013, 33(6): 532-536.
[13] 谭季波,吴欣强,韩恩厚. 动态应变时效对核电材料环境致裂影响的研究现状与进展[J]. 中国腐蚀与防护学报, 2012, 32(6): 437-442.
[14] 周华茂 王俭秋 张波 韩恩厚 臧启山. 轧制AZ31B镁合金腐蚀疲劳过程中的声发射信号分析[J]. 中国腐蚀与防护学报, 2009, 29(2): 81-87.
[15] 张强 . 304不锈钢微尺度试样的腐蚀疲劳性能[J]. 中国腐蚀与防护学报, 2008, 28(2): 99-103 .