Please wait a minute...
中国腐蚀与防护学报  2002, Vol. 22 Issue (4): 198-201          
  研究报告 本期目录 | 过刊浏览 |
冷加工对304不锈钢孔蚀敏感性的影响
胡钢;许淳淳;张新生
北京化工大学材料科学与工程学院
EFFECT OF COLD WORKING ON PITTINGSUSCEPTIBILITY OF 304 STAINLESS STEEL
Gang Hu;Chunchun Xv;Xinsheng Zhang
北京化工大学材料科学与工程学院
引用本文:

胡钢; 许淳淳; 张新生 . 冷加工对304不锈钢孔蚀敏感性的影响[J]. 中国腐蚀与防护学报, 2002, 22(4): 198-201 .
, , . EFFECT OF COLD WORKING ON PITTINGSUSCEPTIBILITY OF 304 STAINLESS STEEL[J]. J Chin Soc Corr Pro, 2002, 22(4): 198-201 .

全文: PDF(141 KB)  
摘要: 对304不锈钢设备由于冷加工产生的马氏体相变进行现场测 试.结果表明,室温下经不同方式、不同程度冷加工后,相关部位的马氏体相变量约在05 %~10%.用电化学动电位极化法、恒电流电位—时间曲线测定法和模拟闭塞电池法研究经 70℃不同程度拉伸变形的304不锈钢在35%NaCl水溶液(50℃±1℃)中的孔蚀击穿电位( Eb)、稳态孔蚀成核电位(Enp)和自腐蚀电位(Ecorr)与马氏体相 变量的关系.在马氏体含量为01%(材料未经冷变形)至115%(材料冷拉伸形变量为10%) 范围内,随马氏体含量增大,Eb、Enp、Ecorr值变负(马氏体 含量为5%时最负),闭塞区内pH值降低,阳极腐蚀电流密度变大,表明冷加工变形不仅诱发 304不锈钢孔蚀,并加速孔蚀发展.
关键词 : 304不锈钢,  马氏体,  孔蚀,  模拟闭塞电池    
Abstract:Cold working induced martensite content on type 304 stainless steel equipment was examined on-site.With different modes and differe nt degree of cold working at room temperature,the martensite content was about 0 . 5%~10%.By potentiodynamic polarization,galvanostatic polarization and simulated occluded corrosion cell methods,the relationship between pitting potential(E b),pitting initiation potential(Enp),corrosion potential(E corr) and martensite content on 304 stainless steel which had been prepared by low temperature(70℃) tensile deformation was investigated in 3.5%NaCl solut ion.Experimental result showed that when the martensite content was between 0.1% (the material without low temperature tensile deformation) and 11.5%(the mate rial with 10% low temperature tensile deformation),with the increas ing of martensite content the potential of Eb,Enp and Ec orr changed negative(when then martensite content is 5%,the potentials were th e most negative),the pH value in occluded cell dropped and the current density i ncreased.It meant that cold working not only accelerated pitting initiation,but also accelerated pitting propagation of 304 stainless steel.
Key words: 304 stainless steel    martensite    pitting    simulated occlu ded cell
收稿日期: 2001-06-29     
ZTFLH:  TG172.5  
[1]HanninenHE .Influenceofmetallurgicalvariablesonenviomentsensitivecrackingofausteniticalloys[J].MetalsRev.,1979,24:85
[2]CigadaA ,MazzaB ,PedeferriP ,etal.Stresscorrosioncrackingofcold-workingausteniticstainlesssteels[J].Corros.Sci.,1982,22(6):558
[3]DingBaofeng,WuYinshun,Abubakir,etal.StudyofdeformationinducedmartensiteandelectrochemicalbehaviorsofAISI304austeniticstainlesssteel[A].AdvancedDevelopmentofCorrosionScienceandProtectionEngineeringTechnology[C].Beijing:Chemi calIndustryPress,1999(丁宝峰,吴荫顺,Abubakir等.AISI304奥氏体不锈钢的形变诱发马氏体相变及其电化学行为的研究[A].腐蚀科学与防腐蚀工程技术新进展[C].北京:化学工业出版社,1999)
[4]FangZhi,WuYinshun,ZhangLin,etal.Effectofdeformationin ducedmartensiteonelectrochemicalbehaviorsoftype304stainlesssteelintheactivestate[J].Corros.Sci.Prote.Technol.,1997,9(1):75(方智,吴荫顺,张琳等.形变诱发马氏体相变对304不锈钢在活化状态下电化学行为的影响[J].腐蚀科学与防护技术,1997,9(1):75)
[5]ZuoJ ,JinZ ,SunR ,etal.AcceleratingeffectandcriticalpHvalueofoccludedcellcorrosionwithin pits,crevices,orstresscorrosioncracks[J].Corrosion,1988,44(8):539
[6]XuChunchun,XuRuifen,OuYangWeizhen,etal.EISstudyoftheeffectofdeformation-inducedα′-martensiteonpittingsensitilityof1Cr18Ni9TistainlesssteelinacidicNaClsolution[J].Corros.Sci.Prote.Technol.,1997,9(2):95(许淳淳,徐瑞份,欧阳维真等.用交流阻抗法研究形变诱发马氏体相变的1Cr18Ni9Ti不锈钢在酸性NaCl溶液中的孔蚀敏感性[J].腐蚀科学与防护技术,1997,9(2):95)
[7]XuRuifen,XuChunchun,XueHuiyong,etal.Effectofα′-marten siteonstabilityofpassivefilmofaustensitestainlesssteel[J].Mate rialsProtection,1998,31(9):7(徐瑞芬,许淳淳,薛慧勇等.奥氏体不锈钢中马氏体含量对其钝化膜稳定性的影响[J].材料保护,1998,31(9):7)
[1] 郑凯, 王艺陶, 王东胜, 刘伟, 蒋颖畅, 黄嵘, 常雪婷. 腐蚀-应力耦合作用对极地船用螺旋桨低碳马氏体不锈钢失效机理影响研究[J]. 中国腐蚀与防护学报, 2026, 46(5): 1452-1462.
[2] 马欢欢, 吕晟东, 钱溢鑫, 林勇, 郝湘平, 张达威, 王鲁宁. 三水醋酸钠相变储热体系中铜换热管的局部腐蚀与寿命预测[J]. 中国腐蚀与防护学报, 2026, 46(4): 1045-1057.
[3] 黄泽邦, 刘光明, 范文学, 徐睿中, 朱炎彬, 刘晨辉. 钝化时间对304不锈钢耐蚀性能的影响[J]. 中国腐蚀与防护学报, 2025, 45(6): 1741-1747.
[4] 张雄斌, 党恩, 于晓婧, 汤玉斐, 赵康. 油气田用马氏体不锈钢腐蚀性能研究现状与进展[J]. 中国腐蚀与防护学报, 2025, 45(4): 837-848.
[5] 张慧云, 郑留伟, 梁伟. 退火工艺对304奥氏体不锈钢的组织演变及氢脆行为的影响[J]. 中国腐蚀与防护学报, 2025, 45(2): 438-448.
[6] 洪孝木, 王永强, 李娜, 田凯, 杜娟. 时效处理对马氏体时效硬化不锈钢显微组织和局部腐蚀性能的影响[J]. 中国腐蚀与防护学报, 2024, 44(5): 1285-1294.
[7] 于佳汇, 王彤彤, 高云, 高荣杰. Bi2S3/TiO2 纳米复合材料的制备及其对304不锈钢的光生阴极保护性能研究[J]. 中国腐蚀与防护学报, 2024, 44(4): 901-908.
[8] 乔泽, 李清泉, 刘晓航, 李燚周. 中性氯化钠溶液中硝酸根和电偶对7075-T651铝合金缝隙腐蚀行为影响研究[J]. 中国腐蚀与防护学报, 2024, 44(4): 1047-1054.
[9] 叶梦颖, 于佳汇, 王彤彤, 高荣杰. Bi2S3/CdS/TiO2 纳米复合材料的制备及对304不锈钢的光生阴极保护性能研究[J]. 中国腐蚀与防护学报, 2024, 44(2): 372-380.
[10] 任万凯, 连洲洋, 周康, 罗正维, 魏无际, 张雪英. 氨法脱硫液成分对304不锈钢局部腐蚀发展阶段影响探究[J]. 中国腐蚀与防护学报, 2023, 43(6): 1392-1398.
[11] 李佳媛, 曾天昊, 刘友通, 吴晓春. 加铜4Cr16Mo马氏体不锈钢在应力作用下的腐蚀研究[J]. 中国腐蚀与防护学报, 2023, 43(5): 1094-1100.
[12] 毛飞雄, 周羽婷, 姚文清, 沈翔, 肖龙, 李明辉. 基于PDM的304不锈钢钝化膜生长动力学研究[J]. 中国腐蚀与防护学报, 2023, 43(4): 911-921.
[13] 陈志坚, 周学杰, 陈昊. 高速列车铆接件中6A01铝合金腐蚀行为研究[J]. 中国腐蚀与防护学报, 2022, 42(3): 507-512.
[14] 苏娜, 叶梦颖, 李建民, 高荣杰. ZIF-8/TiO2纳米复合材料的制备及光生阴极保护性能[J]. 中国腐蚀与防护学报, 2022, 42(2): 267-273.
[15] 安易强, 王昕, 崔中雨. 硝酸钝化对304不锈钢在模拟混凝土孔隙液中点蚀的临界Cl-浓度的影响[J]. 中国腐蚀与防护学报, 2021, 41(6): 804-810.