氮化物涂层对钛合金抗循环氧化性能的影响

中国腐蚀与防护学报

2012, Vol. 32

Issue (1): 7-12

研究报告

本期目录 | 过刊浏览

氮化物涂层对钛合金抗循环氧化性能的影响

陈倩^1,2,辛丽²,滕英元¹,朱圣龙²,王福会²

1. 沈阳航空航天大学航空宇航工程学院沈阳 110136
2. 中国科学院金属研究所金属腐蚀与防护国家重点实验室沈阳 110016

EFFECT OF NITRIDE COATINGS ON THE CYCLIC OXIDATION BEHAVIOR OF TI6AL4V ALLOY

CHEN Qian^1,2, XIN Li², TENG Yingyuan¹, ZHU Shenglong², WANG Fuhui²

1. Shenyang Aerospace University, School of Aerospace Engineering, Shenyang 110136
2. State Key Laboratory for Corrosion and Protection, Institute of Metal Research, Chinese Academy of Sciences, Shenyang 110016

全文: PDF(3200 KB)

摘要: 用多弧离子镀技术在Ti6Al4V钛合金表面沉积Ti_0.5Al_0.5N/Ti_0.7Al_0.3N复合涂层和Ti_0.6Al_0.3Si_0.1N涂层，研究其在550℃~750℃下的抗循环氧化性能。结果表明，TiAlSiN涂层以及Ti_0.5Al_0.5N/Ti_0.7Al_0.3N复合涂层在550℃和650℃氧化后表面形成薄而连续的保护性富铝氧化膜，显著提高了Ti6Al4V的抗氧化性能。在750℃下，TiAlSiN涂层涂敷的Ti6Al4V依然保持着优异的抗循环氧化性能，而Ti_0.5Al_0.5N/Ti_0.7Al_0.3N复合涂层却不能为钛合金提供有效的防护。

关键词 ：多弧离子镀, Ti_0.5Al_0.5N/Ti_0.7Al_0.3N复合涂层, TiAlSiN涂层, Ti6Al4V, 循环氧化

Abstract：Ti_0.5Al_0.5N/Ti_0.7Al_0.3N double-layered film and Ti_0.6Al_0.3Si_0.1N film were deposited on Ti6Al4V alloy by the arc ion plating (AIP) method. It was found that the deposition of the films of the two types significantly improved cyclic oxidation resistance of the Ti6Al4V alloy at 550℃ and 650℃, due to the formation of a thin and continuous Al₂O₃-rich scale. At 750℃, a good cyclic oxidation resistance still remained for the Ti_0.6Al_0.3Si_0.1N-coated Ti6Al4V but not for the Ti_0.5Al_0.5N/Ti_0.7Al_0.3N-coated alloy.

Key words： arc ion plating(AIP) Ti_0.5Al_0.5N/Ti_0.7Al_0.3N double-layered film TiAlSiN film Ti6Al4V alloy cyclic oxidation

收稿日期: 2010-10-21

ZTFLH:

TG139

通讯作者: 陈倩 E-mail: cq1106@163.com

Corresponding author: CHEN Qian E-mail: cq1106@163.com

作者简介: 陈倩，女，1985年生，硕士生，研究方向为材料微观力学

	服务

	把本文推荐给朋友
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章
	陈倩
44.8K

引用本文:

陈倩,辛丽,滕英元,朱圣龙,王福会. 氮化物涂层对钛合金抗循环氧化性能的影响[J]. 中国腐蚀与防护学报, 2012, 32(1): 7-12.
CHEN Qian. EFFECT OF NITRIDE COATINGS ON THE CYCLIC OXIDATION BEHAVIOR OF TI6AL4V ALLOY. J Chin Soc Corr Pro, 2012, 32(1): 7-12.

链接本文:

https://www.jcscp.org/CN/ 或 https://www.jcscp.org/CN/Y2012/V32/I1/7

[1] Shida Y, Anada H. The influence of ternary element addition on the oxidation behavior of TiAl intermetallic compound in high-temperature air [J]. Corros. Sci., 1993, 35 (5-8): 945-953

[2] Du H L, Datta P K, Bumell-Gray J S. Effect of Nb coating on the sulphidation oxidation behavior of Ti and Ti-6Al-4V alloy [J]. J. Mater. Sci., 1995, 10(30): 2640-2647

[3] Tang Z L, Wang F H, Wu W T. Effect of a sputtered TiAlCr coating on hot corrosion resistance of gamma-TiAl [J].Intermetallics, 1999, 7: 1271-1274

[4] Leyens C, Peters M, Kaysser W A. Intermetallic Ti-Al coatings for protection of titanium alloys: oxidation and mechanical behavior [J].Surf. Coat. Technol., 1997, 94-95: 34-40

[5] Tang Z L, Wang F H, Wu W T, et al. Effect of coatings on oxidation resistance and mechanical performance of Ti60 alloy [J].Mater. Sci. Eng., 1998, A255: 133-138

[6] Liu H P, Hao S S, Wang X H, et al. Interaction of a near-α type titanium alloy with NiCrAlY protective coating at high temperatures [J]. Scr. Mater., 1998, 39: 1443-1450

[7] Zhou C G, Cai R, Gong S K, et al. Hot corrosion of AlCuFeCr quasicrystalline coating on titanium alloys with NaCl deposit [J]. Surf. Coat. Technol., 2006, A201(3-4): 1718-1723

[8] Gurappa I. Protection of titanium alloy components against high temperature corrosion [J]. Mater. Sci. Eng., 2003, A356(1-2): 372-380

[9] Xiong H P, Mao W, Ma W L, et al. Liquid-phase aluminizing and siliconizing at the surface of a Ti60 alloy and improvement in oxidation resistance [J]. Mater. Sci. Eng., 2006, A433: 108-113

[10] Xiong Y M, Zhu S L, Wang F H. The oxidation behavior and mechanical performance of Ti60 alloy with enamel coating [J]. Surf.Coat. Technol., 2005,190: 195-199

[11] Leyens C, Peters M, Hvsepian P E, et al. Novel coating systems produced by the combined cathodic arc/unbalanced magnetron sputtering for environmental protection of titanium alloys [J]. Surf. Coat. Technol., 2002, 155: 103-111

[12] Vennemann A, Stock H R, Kohlscheen J, et al. Oxidation resistance of titanium-aluminium-silicon nitride coatings[J]. Surf. Coat. Technol., 2003, 174-175: 408-415

[13] Li M S, Wang F H. Effects of nitrogen partial pressure and pulse bias voltage on (Ti,Al)N coatings by arc ion plating [J].Surf. Coat. Technol., 2003, 167: 197-202

[14] Shalev S, Boxman R L, Goldsmith S. Velocities and emission rates of cathode-produced molybdenum macroparticles in a vacuum arc [J]. J. Appl. Phys., 1985, 58(7): 2503-2507

[15] Boxman R L, Goldsmith S. Macroparticles contamination in cathodic arc coatings: generation, transport and control [J]. Surf.Coat. Technol., 1992, 52(39): 39-59

[16] Feng C J , Li M S , Xin L, et al. Mechanical properties and oxidation behavior of a graded (Ti,Al)N coating deposited by arc-ion plating [J]. Oxid. Met., 2006, 65(5/6): 307-327

[1]	张瑞,李雨,关蕾,王冠,王福雨. 热处理对激光选区熔化Ti6Al4V合金电化学腐蚀行为的影响[J]. 中国腐蚀与防护学报, 2019, 39(6): 588-594.
[2]	艾鹏,刘礼祥,李晓罡,姜文涛. TiAlSiN涂层对γ-TiAl基合金抗高温氧化性能的影响[J]. 中国腐蚀与防护学报, 2019, 39(4): 306-312.
[3]	张明明,辛丽,丁学勇,耿树江,朱圣龙,王福会. 600 ℃/NaCl-H₂O-O₂协同环境中Ti/TiAlN多层涂层的耐蚀行为[J]. 中国腐蚀与防护学报, 2017, 37(1): 29-35.
[4]	肖斌,向军淮,张洪华. 四元Fe-Cu-Ni-Al合金900 ℃下的恒温及循环氧化行为[J]. 中国腐蚀与防护学报, 2017, 37(1): 69-73.
[5]	赵时璐张钧刘常升. 多弧离子镀(Ti, Al, Zr, Cr) N多元膜的高温氧化行为[J]. 中国腐蚀与防护学报, 2009, 29(4): 296-300.
[6]	范爱兰; 秦妍梅; 秦林; 常大庆; 唐宾 . Ti6Al4V合金离子渗Mo组织结构及其腐蚀性能研究[J]. 中国腐蚀与防护学报, 2007, 27(1): 31-34 .
[7]	金光熙; 乔利杰; 高克玮; 桥本健纪 ; 褚武扬 . Al60Mn13Ti25V2金属间化合物的高温氧化行为研究[J]. 中国腐蚀与防护学报, 2004, 24(3): 129-134 .
[8]	宋复斌; 张琦 . 常温腐蚀对Al-Si涂层循环氧化行为的影响[J]. 中国腐蚀与防护学报, 2003, 23(3): 183-186 .
[9]	张重远; 李美恒; 孙晓峰 . 单晶高温合金热障涂层的循环氧化行为[J]. 中国腐蚀与防护学报, 2002, 22(2): 111-114 .
[10]	袁福河; 孙晓峰; 管恒荣 . 钴基高温合金的循环氧化行为研究[J]. 中国腐蚀与防护学报, 2002, 22(2): 115-117 .
[11]	耿树江; 王福会; 朱圣龙 . 溅射纳米晶IN738合金涂层的抗循环氧化行为[J]. 中国腐蚀与防护学报, 2001, 21(6): 334-339 .
[12]	胡武生;李铁藩;沈嘉年. 几种Ni-Cr-Al墓低偏析高温合金的抗氧化性能研究[J]. 中国腐蚀与防护学报, 1996, 16(4): 293-297.

Viewed

Full text

Abstract

Cited

Shared

Discussed