Please wait a minute...
中国腐蚀与防护学报  1996, Vol. 16 Issue (2): 133-139         
  研究报告 本期目录 | 过刊浏览 |
电解电容器铝箔纯交流腐蚀工艺影响因素的研究
张三平;李跃喜;邹瑞海;尹世奇
武汉材料保护研究所;武汉市无线电电容器厂
A STUDY OF FACTORS INFLUENCING AC ETCHING OF ALUMINIUM CAPACITOR FOIL
Zhang Sanping;Li Yuexi;Zou Ruihai(Wuhan Research Institute of Materials Protection)Yi Shiqi(Wuhan Electrolytic Capacitor Factory )
引用本文:

张三平;李跃喜;邹瑞海;尹世奇. 电解电容器铝箔纯交流腐蚀工艺影响因素的研究[J]. 中国腐蚀与防护学报, 1996, 16(2): 133-139.
, , , . A STUDY OF FACTORS INFLUENCING AC ETCHING OF ALUMINIUM CAPACITOR FOIL[J]. J Chin Soc Corr Pro, 1996, 16(2): 133-139.

全文: PDF(1247 KB)  
摘要: 对电解电容器铝箔交流腐蚀体系中各影响因素的研究结果表明,在电流密度为0.5A/cm2,温度为47±2℃;控制腐蚀液中Al(3+)含量及适量添加表面保护剂和辅助添加剂的条件下,可获得最大比电容。通过循环伏安曲线测试,探讨了各因素影响腐蚀的机理及相互关系。
关键词 : 电解电容器,  交流腐蚀,  铝箔    
Abstract:Alternating current etching is an important technique for increasing the specific surface area of aluminium capacitor foil for low voltage use. The present research was carried out on the influence of etchant bath composition and operating parameters to obtain a desirable surface morphology and high capacitance of the etched foil while keeping its tensile strength within the required range. Experimental results showed that the etched foil with the largest capacitance up to 33 μF/cm2 could be obtained at a temperature of 47±2℃ and current density of 0.5A/cm2 in a hydrochloric acid etching solution containing a proper surface protectant and another auxiliary additive with the Al3+ concentration from 5.36 to 6.55g/L. Cyclic voltammetric curves were measured to explain the mechanism and effects of above-mentioned factors on AC etching.
Key words: AC etching    Electrolytic capacitor    Aluminium foil
收稿日期: 1996-04-25     
1日本公开特许,昭61-1987102UnitedStatesPatent43326512;1982,Jun13MooreWM.Corrosion,1984,40(12):6444松木健三,立花和宏,船越明.金属表面技术,1987,38(6):2465QuangKVaBrindelF.J.ElectrochemSoc,1983,130(6):12486沈行素,林海潮,阎康平.应用化学,1986,3?(3):407DyerCK,AlwittRS.J.Electrochem.Soc,1981,Feb.,3
[1] 王承涛, 申冠一, 许少毅, 李威, 王禹桥, 王树臣, 闻东东, 李朋宇. 基于物理场耦合的交流干扰作用下埋地金属管线腐蚀数值仿真[J]. 中国腐蚀与防护学报, 2024, 44(6): 1573-1580.
[2] 郑重, 周远翔, 李永印. 锅炉电极材料交流腐蚀特性与选型研究[J]. 中国腐蚀与防护学报, 2023, 43(1): 202-208.
[3] 于帅先, 吴亚军, 武海生, 吴量, 麻彦龙, 邓盛卫, 孙立东. 钛酸酯改性硅烷涂层优化及其对5056铝箔耐蚀性能的影响[J]. 中国腐蚀与防护学报, 2022, 42(3): 378-386.
[4] 邓佳丽, 闫茂成, 高博文, 张辉. 高铁动态交流干扰下管道钢的腐蚀行为试验研究[J]. 中国腐蚀与防护学报, 2022, 42(1): 127-134.
[5] 梁毅, 杜艳霞. 交流干扰和阴极保护协同作用下的腐蚀评判标准与机理研究进展[J]. 中国腐蚀与防护学报, 2020, 40(3): 215-222.
[6] 董亮,路民旭,杜艳霞,姜子涛. 埋地管道交流腐蚀的研究进展[J]. 中国腐蚀与防护学报, 2011, 31(3): 173-178.
[7] 杨文峰 刘瑞泉. 咪唑啉缓蚀剂对电解电容器用铝箔直流扩面增容的作用[J]. 中国腐蚀与防护学报, 2009, 29(6): 499-503.
[8] 冯哲圣; 肖占文; 杨邦朝 . 铝箔交流扩面腐蚀中SO42-缓蚀机理的研究[J]. 中国腐蚀与防护学报, 2003, 23(2): 70-74 .
[9] 肖占文; 杨邦朝 . 铝箔交流腐蚀的阴极半周期间表面酸度变化与腐蚀产物膜的形成[J]. 中国腐蚀与防护学报, 1999, 19(4): 200-206 .
[10] 肖占文; 杨邦朝 . 交流负半周对高纯铝在盐酸溶液中点蚀行为的影响[J]. 中国腐蚀与防护学报, 1999, 19(4): 193-199 .