|
|
Corrosion Behavior of Extra Deep Drawing Cold Rolled Sheet in Stimulative Ocean-atmosphere Environment |
Chengliang MAO1,Kui XIAO1,2( ),Chaofang DONG1,2,Junsheng WU1,2,Lidan YAN1,Li JIANG1 |
1 Corrosion and Protection Center, University of Science and Technology Beijing, Beijing 100083, China 2 Key Laboratory for Corrosion and Protection (MOE), University of Science and Technology Beijing, Beijing 100083, China |
|
|
Abstract The conversion period for the corrosion data of steels acquired respectively by the outerdoor exposure test and the indoor neutral salt spray test, which aims to simulate the corrosivity of the marine atmospheric environment at Wanning, was calculated by means of the equivalent conversion method, while taking the real marine atmospheric environmental data over the past three years at Wanning area into account. Then the corrosion behavior of an extra deep drawing cold rolled sheet DC06 and a carbon steel Q235 was comparatively studied through neutral salt spray test for desired conversion periods. In the meanwhile, the correlation between the results of the indoor neutral salt spray accelerated test and the outdoor air exposure test at Wanning is quantitatively studied by the grey correlation degree method. The results show that the corrosion kinetics curves of DC06 and Q235 by neutral salt spray test are in accordance with the power function law. For DC06 and Q235, their relevant results of neutral salt spray test for the conversion period (528 ha-1) and the common period (480 ha-1) respectively showed gray correlation degrees greater than 0.6 with those of the outdoor atmospheric exposure test at Wanning,indicating that the corrosion dynamics results measured indoor and outdoor respectively are of consistency. It is noted that the grey correlation degrees for the outdoor test results with those of indoor test for the conver sion period are higher than those for the common period.
|
Received: 14 October 2016
|
[1] | Kang H J.Research and development of extra-deep drawing DC06 [D]. Shenyang: Northeastern University, 2009 | [1] | (康海军. 汽车用超深冲钢DC06的研制开发 [D]. 沈阳: 东北大学, 2009) | [2] | Li G Y, Zhou J Z.Development and application of high grade auto sheet steels[J]. J. Iron Steel Res., 2012, 24(suppl.1): 1 | [2] | (李光瀛, 周积智. 高等级汽车板的开发与应用[J]. 钢铁研究学报, 2012, 24(增刊1): 1) | [3] | Yang X H, Jin P.Compile of aircraft operation environment spectrum[J]. Equip. Environ. Eng., 2010, 7(6): 99 | [3] | (杨晓华, 金平. 飞机使用环境谱的编制[J]. 装备环境工程, 2010, 7(6): 99) | [4] | Zhang X J, Shu D X, Chen J Q.Study on the weather and corrosion characteristics of Wanning exposure site[J]. Equip. Environ. Eng., 2005, 2(4): 73 | [4] | (张先勇, 舒德学, 陈建琼. 海南万宁试验站大气环境及腐蚀特征研究[J]. 装备环境工程, 2005, 2(4): 73) | [5] | Bai Z H, Huang Y H, Li X G, et al.Environmental corrosion in industrial-marine atmosphere at Qingdao of 7050 Al-alloy anodized in boric- and sulfuric-acid electrolyte[J]. J. Chin. Soc. Corros. Prot., 2016, 36: 580 | [5] | (白子恒, 黄运华, 李晓刚等. 硫硼酸阳极氧化处理的7050铝合金在工业海洋大气中的腐蚀行为[J]. 中国腐蚀与防护学报, 2016, 36: 580) | [6] | Zhang D D, Zhao C Y, Wang C, et al.Atmospheric aerosols corrosion[J]. J. Chin. Soc. Corros. Prot., 2015, 35: 91 | [6] | (张丹丹, 赵春英, 汪川等. 大气气溶胶腐蚀[J]. 中国腐蚀与防护学报, 2015, 35: 91) | [7] | Tang Q H, Li J N, Dai H.Contrast research on corrosivity of Wanning seaside and Xisha Islands atmosphere[J]. Equip. Environ. Eng., 2010, 7(6): 1 | [7] | (唐其环, 李军念, 代红. 万宁滨海与西沙群岛大气腐蚀性对比研究[J]. 装备环境工程, 2010, 7(6): 1) | [8] | Liu C C, Lu G F, Zhang J K, et al.Differences between environment spectrums of 2A12 and 30CrMnSiA in the same ocean atmospheric environment[J]. Corros. Prot., 2015, 36: 609 | [8] | (刘成臣, 鲁国富, 张金奎等. 2A12与30CrMnSiA在相同海洋大气环境中的加速环境谱差异[J]. 腐蚀与防护, 2015, 36: 609) | [9] | Yu Q C, Wang Z Y, Wang C.Corrosion behaviors of low alloy steel and carbon steel deposited with NaCl and NaHSO3 under dry/humid alternative condition[J]. Acta Metall. Sin., 2010, 46: 1133 | [9] | (于全成, 王振尧, 汪川. 表面沉积NaCl和NaHSO3的低合金钢和碳钢在干湿交替条件下的腐蚀行为[J]. 金属学报, 2010, 46: 1133) | [10] | Liu G C, Dong J H, Han E-H, et al.Progress in research on rust layer of weathering steel[J]. Corros. Sci. Prot. Technol., 2006, 18: 268 | [10] | (刘国超, 董俊华, 韩恩厚等. 耐候钢锈层研究进展[J]. 腐蚀科学与防护技术, 2006, 18: 268) | [11] | Ma Y T, Li Y, Wang F H.Corrosion of low carbon steel in atmospheric environments of different chloride content[J]. Corros. Sci., 2009, 51: 997 | [12] | Ma Y T, Li Y, Wang F H.The effect of β-FeOOH on the corrosion behavior of low carbon steel exposed in tropic marine environment[J]. Mater. Chem. Phys., 2008, 112: 844 | [13] | Evans V R.The Corrosion and Oxidation of Metals: Second Supplementary Volume[M]. London, England: Edward Arnold, 1976 | [14] | Matsushima I, Ueno T.On the protective nature of atmosph rust on low-alloy steel[J]. Corros. Sci., 1971, 11: 129 | [15] | Moutarlier V, Gigandet M P, Normand B, et al.EIS characterisation of anodic films formed on 2024 aluminium alloy, in sulphuric acid containing molybdate or permanganate species[J]. Corros. Sci., 2005, 47: 937 |
|
No Suggested Reading articles found! |
|
|
Viewed |
|
|
|
Full text
|
|
|
|
|
Abstract
|
|
|
|
|
Cited |
|
|
|
|
|
Shared |
|
|
|
|
|
Discussed |
|
|
|
|