|
|
Influence of Calcareous Deposit on Corrosion Behavior of Q235 Carbon Steel in f/2 Culture Medium with Amphora |
Jiangwei WANG1,2,Jie ZHANG2( ),Shougang CHEN1,Jizhou DUAN2,Baorong HOU2 |
1. College of Material Science and Engineering, Ocean University of China, Qingdao 266100, China 2. Key Laboratory of Marine Environmental Corrosion and Bio-fouling, Institute of Oceanology, Chinese Academy of Science, Qingdao 266071, China |
|
|
Abstract Calcareous deposit was formed on Q235 carbon steel surface in nature seawater by applying cathodic protection, afterwards, the corrosion test of the steel covered with and without calcareous deposit was carried out in f/2 culture medium containing Amphora. Then the morphology and chemical composition of corrosion products were characterized by means of XRD, SEM, FTIR and EIS. The result revealed that the calcareous deposit prepared by a current density of -30 µA/cm2 showed an even- and uniform-surface morphology composed of nice crystalline phase. The Amphora and its metabolite could adhere to the steel surface forming a biofilm, which could suppress the mass transfer of corrosive species from the medium to the steel surface to some extent, but not obviously that of the oxygen. Calcareous deposit was apt to combine with Amphora forming a composite film on the steel surface, which then could rather effectively suppress the migration of oxygen. The corrosion process of Q235 steel beneath the composite film can be described as the following three stages: as the corrosive media penetrated the composite film on to the steel surface, the steel is corroded leading to the formation of corrosion products, while, with which the combination of the existed biofilm, thus the composite film could act as barrier enabling the corrosion rate to be decreased to some extent; later as damages occurred within the composite film, thereby its protectiveness deteriorated, the corrosion rate of the steel increased again.
|
|
[1] | Hou B R.Theory and Application of Marine Corrosion Environment[M]. Beijing: Science Press, 1999 | [1] | (侯保荣. 海洋腐蚀环境理论及其应用 [M]. 北京: 科学出版社, 1999) | [2] | Ch Barchiche, Deslouis C, Festy D, et al.Characterization of calcareous deposits in artificial seawater by impedance techniques 3-Deposit of CaCO3 in the presence of Mg (II)[J]. Electrochim. Acta, 2003, 48: 1645 | [3] | Rakitin A R, Kichigin V I.Electrochemical study of calcium carbonate deposition on iron: Effect of the anion[J]. Electrochim. Acta,2009, 54: 2647 | [4] | Rousseau C, Baraud F, Leleyter L, et al.Calcareous deposit formed under cathodic protection in the presenceof natural marine sediments: A 12 month experiment[J]. Corros. Sci., 2010, 52: 2206 | [5] | Gabrielli C, Keddam M, Khalil A, et al.Study of calcium carbonate scales byelectrochemical impedance spectroscopy[J]. Electrochim. Acta, 1997, 42: 1207 | [6] | Sosa E, Garcia-Arriaga V, Castaneda H.Impedance distri bution at the interface of the API steel X65 in marine environment[J]. Electrochim. Acta, 2006, 51: 1855 | [7] | Liu S X, Wang Y, Zhang D, et al.Electrochemical behavior of 316L stainless steel in f/2 culture solutions containing chlorella vulgaris[J]. Int. J. Electrochem. Sci., 2013, 8: 5330 | [8] | Eashwar M, Sathish K P, Ravishankar R, et al.Sunlight-enhanced calcareous deposition on cathodic stainless steel in natural seawater[J]. Biofouling, 2013, 29(2): 185 | [9] | Blackwood D J, Lim C S, Teo S L M. Influence of fouling on the efficiency of sacrificial anodes in providing cathodic protection in southeast asian tropical seawater[J]. Biofouling, 2010, 26(7): 779 | [10] | Landoulsi J, Cooksey K E, Dupres V.Review-Interactions between diatoms and stainless steel: focus on biofouling and biocorrosion[J]. Biofouling, 2011, 27(10): 1105 | [11] | Dattesh V D.Impact of Irgarol 1051 on the larval development and metamorphosis of Balanusamphitrite darwin, the diatom Amphora coffeaformis and natural biofilm[J]. Biofouling, 2008, 24(5): 393 | [12] | Ates M.Review study of electrochemical impedance spectroscopy and equivalent electrical circuits of conducting polymers on carbon surfaces[J]. Prog. Org. Coat., 2011, 71: 1 | [13] | Galicia P, Batina N, González I.The relationship between the surface composition and electrical properties of corrosion films formed on carbon steel in alkaline sour medium: An XPS and EIS study[J]. J. Phys. Chem., 2006, 110B: 14398 | [14] | Okhrimenko D V, Nissenbaum J, Andersson M P, et al.Energies of the adsorption of functional groups to calcium carbonate polymorphs: The importance of -OH and -COOH groups[J]. Langmuir, 2013, 29: 11062 | [15] | Le Thu Q, Takenouti H, Touzain S.EIS characterization of thick flawed organic coatings aged under cathodic protection in seawater[J]. Electrochim. Acta, 2006, 51: 2491 | [16] | Qian B, Hou B R, Zheng M.The inhibition effect of tannic acid on mild steel corrosion in seawater wet/dry cyclic conditions[J]. Corros. Sci.,2013, 72: 1 | [17] | Nasrazadani S, Diaza J, Stevens J, et al.Effects of DBU, morpholine, and DMA oncorrosion of low carbon steel exposed to steam[J]. Corros. Sci., 2007, 49: 3024 | [18] | Cao S, Wang J D, Chen H S, et al.Progress of marine biofouling and antifouling technologies[J]. Chin. Sci. Bull., 2011, 56: 598 | [19] | Geesey G G, Wigglesworth-Cooksey B, Cooksey K Z.Influence of calcium and other cations on surface adhesion of bacteria and diatoms: A review[J]. Biofouling, 2000, 15(1-3), 195 |
|
No Suggested Reading articles found! |
|
|
Viewed |
|
|
|
Full text
|
|
|
|
|
Abstract
|
|
|
|
|
Cited |
|
|
|
|
|
Shared |
|
|
|
|
|
Discussed |
|
|
|
|