Please wait a minute...
中国腐蚀与防护学报  2010, Vol. 30 Issue (5): 383-390    
  研究报告 本期目录 | 过刊浏览 |
基于固结试验和接触理论分析的铁锈力学性能
赵羽习1,任海洋1,2
1. 浙江大学结构工程研究所 杭州 310058
2. 中国水电顾问集团华东勘测设计研究院 杭州 310014
MECHANICAL BEHAVIOR OF THE RUST BASED ON OEDOMETER TEST AND HERTZ CONTACT THEORY
ZHAO Yuxi1, REN Haiyang1,2
1. Institute of Structure Engineering,Zhejiang University,Hangzhou 310058
2. HydroChina HuaDong Engineering Corporation, Hangzhou 310014
全文: PDF(1021 KB)  
摘要: 选取自然锈蚀、电解锈蚀两种锈蚀产物颗粒作为研究对象,采用X射线衍射(XRD)、显微镜观测等方法研究两者物理性能上的差异。通过改进的固结试验方法,同时引入Hertz弹性接触理论,对不同粒径的不同锈蚀产物进行不同荷载作用下的模量分析计算,得到了不同荷载与铁锈模量之间的关系,表明铁锈不是线弹性物质,铁锈模量随荷载呈线性增加趋势。在试验结果基础上,还考虑尺寸效应影响,提出了自然锈蚀产物颗粒的内部损失表达式,并对自然锈蚀产物颗粒的内部损失进行定量分析,可描述理想无损自然锈蚀产物的力学性能。
关键词 锈蚀产物固结试验Hertz接触理论力学性能尺寸效应    
Abstract:Steel corrosion occurs in concrete structures when proper environmental conditions are provided. After steel corrosion initiates, the corrosion products first accumulate at the steel surface, then induce an internal pressure on the surrounding confining concrete, and slowly apply stress to the concrete cover until cracks are initiated at the steel surface spreading towards to the concrete surface. Therefore, corrosion product is the most influential factor during the concrete cracking process due to corrosion. Natural rust and electrochemical steel corrosion were investigated by X-ray diffraction (XRD) and digital optical microscope to differentiate the physical characters of two types of rusts. The oedometer tests were used to analyze the mechanical behavior of the powder rust samples, the modulus of these two types of rusts were then deduced according to Hertz contact theory. It was observed that the modulus of rust increased with the load increasing. By quantitative analysis of the inner damage constitutive model of natural corrosion products, the scale effect was accounted into the rust modulus model. The mechanical behavior of ideal natural rust was then described.
Key wordsrust    oedometer test    Hertz contact theory    mechanical behavior    scale effect
收稿日期: 2009-08-20     
ZTFLH: 

TU375

 
基金资助:

国家自然科学基金项目(50808157)资助

通讯作者: 任海洋     E-mail: renhaiyang@zju.edu.cn
Corresponding author: ren haiyang     E-mail: renhaiyang@zju.edu.cn
作者简介: 赵羽习,1973年生,女,教授,博士,研究方向为混凝土结构耐久性

引用本文:

赵羽习,任海洋. 基于固结试验和接触理论分析的铁锈力学性能[J]. 中国腐蚀与防护学报, 2010, 30(5): 383-390.
DIAO Hu-Xi, REN Hai-Xiang. MECHANICAL BEHAVIOR OF THE RUST BASED ON OEDOMETER TEST AND HERTZ CONTACT THEORY. J Chin Soc Corr Pro, 2010, 30(5): 383-390.

链接本文:

https://www.jcscp.org/CN/      或      https://www.jcscp.org/CN/Y2010/V30/I5/383

[1] Bazant Z P. Physical model for steel corrosion in concrete sea structures-application [J]. J. Struct. Divi., 1979, 105(6): 1155-1166 [2] Liu Y P, Weyers R E. Modeling the time to corrosion cracking in chloride contaminated reinforced concrete structures [J]. Mater. J., 1998, 95(6): 675-681 [3] Zhao Y X, Jin W L. Numerical-based method for calculating reinforcement corrosion at concrete cover cracking due to corrosion [J]. J. Zhejiang Univ. (Eng, Sci.),2008, 42(6): 1080-1084     (赵羽习,金伟良. 混凝土锈胀时刻钢筋锈蚀率的数值分析方法 [J]. 浙江大学学报(工学版), 2008, 42(6): 1080-1084) [4] Molina F J, Alonso C, Andrade C. Cover cracking as a function of rebar corrosion: Part 2-Numerical model [J]. Mater,Struct., 1993, 26: 532-548 [5] Peter-Lazar, Gerard. Mechanical behaviour of corrosion products formed at the steel-concrete interface. Testing and modeling. [A] In Proceedings EM2000,Fourteenth Engineering Mechanics Conference [D]. Austin, Texas: 2000 [6] Lundgren K. Bond between ribbed bars and concrete. Part 2: The effect of corrosion [J]. Mag. Concr. Res., 2005,57(7): 383-395 [7] Kapilesh Bhargava, Ghosh A K, Yasuhiro Mori, et al. Analytical model for time to cover cracking in RC structures due to rebar corrosion [J]. Nuclear Eng.Des, 2006, 236: 1123-1139 [8] Care S, Nguyen Q T, L'Hostis V, et al. Mechanical properties of the rust layer induced by impressed current method in reinforced mortar [J]. Cem.Concr. Res., 2008, 38: 1079-1091 [9] Ouglova A, Francois M, Berthaud Y, et al. Mechanical properties of an iron oxide formed by corrosion in reinforced concrete structures [J]. Phys. IV France, 2006, 136: 99-107 [10] Johnson K L. Contact Mechanics [M]. Cambridge: Cambridge University Press, 1987. [11] Yang S Q, Xu W Y, Su C D. Study on statistical damage constitutive model of rock considering scale effect [J]. Chin. J. Rock Mech. Eng., 2005, 24(24): 4484-4490      (杨圣奇,徐卫亚,苏承东. 考虑尺寸效应的岩石损伤统计本构模型研究 [J]. 岩石力学与工程学报, 2005, 24(24):4484-4490)
[1] 陈磊,裴志亮,肖金泉,宫骏,孙超. 磁过滤电弧离子镀制备TiAlN涂层的结构与性能表征[J]. 中国腐蚀与防护学报, 2017, 37(3): 241-246.
[2] 程旭东,孙连方,曹志烽,朱兴吉. 钢筋非均匀锈蚀导致的混凝土保护层锈胀开裂过程分析[J]. 中国腐蚀与防护学报, 2015, 35(3): 257-264.
[3] 吴涛涛, 孟威威, 鲍志荣, 李洋, 潘春旭. 过量CO2气氛环境下青铜表面生成孔雀石锈蚀产物的模拟研究[J]. 中国腐蚀与防护学报, 2014, 34(1): 82-88.
[4] 吴进怡,罗琦,肖伟龙,柴柯,曹阳. 海水环境中弧菌对45钢腐蚀行为及力学性能的影响[J]. 中国腐蚀与防护学报, 2012, 32(4): 343-348.
[5] 钟曼英. 氢对2(1/4)Cr-1Mo钢力学性能的影响[J]. 中国腐蚀与防护学报, 2011, 31(3): 236-239.
[6] 杨秀英, 赵艳红, 彭晓, 王福会. Cr,Al 颗粒尺寸对Ni-Cr-Al复合镀层氧化行为的影响[J]. 中国腐蚀与防护学报, 2011, 31(3): 190-195.
[7] 黄凰,秦颍,徐劲松. 湖北鄂州出土青铜器锈蚀状况分析[J]. 中国腐蚀与防护学报, 2011, 31(1): 76-80.
[8] 肖伟龙,柴柯,杨雨辉,吴进怡. 25钢在热带海洋环境下海水中的微生物腐蚀及其对力学性能的影响[J]. 中国腐蚀与防护学报, 2010, 30(5): 359-363.
[9] 黄文静;黄华良;邱于兵;陈振宇;郭兴蓬. 尺寸效应对微电极腐蚀行为的影响[J]. 中国腐蚀与防护学报, 2010, 30(2): 141-144.
[10] 薛艳;赵国仙;董会;赵大伟. 5Cr油管电化学充氢后的力学行为[J]. 中国腐蚀与防护学报, 2010, 30(1): 89-92.
[11] 俞芳 高克玮 路民旭. 流动状态下X65管线钢CO2腐蚀产物膜结构和力学性能的评价[J]. 中国腐蚀与防护学报, 2009, 29(6): 401-404.
[12] 孙霜青 郑弃非 李德富 陈杰 温军国. LY12铝合金的长期大气腐蚀行为[J]. 中国腐蚀与防护学报, 2009, 29(6): 442-446.
[13] 李美姮; 管恒荣 . 热障涂层的性能评价[J]. 中国腐蚀与防护学报, 2007, 27(5): 309-314 .
[14] 汪淑英; 李具仓; 赵爱民 . 含铬高硅铁基合金组织和性能的研究[J]. 中国腐蚀与防护学报, 2007, 27(5): 292-295 .
[15] 罗天元 . 高比重钨合金材料的腐蚀特性[J]. 中国腐蚀与防护学报, 2004, 24(6): 356-359 .