原奥氏体晶粒度对40CrNiMoA钢在蒸馏水中的应力腐蚀和腐蚀疲劳断裂过程的影响

中国腐蚀与防护学报

1987, Vol. 7

Issue (3): 189-197

研究报告

本期目录 | 过刊浏览

原奥氏体晶粒度对40CrNiMoA钢在蒸馏水中的应力腐蚀和腐蚀疲劳断裂过程的影响

杨正瑞;徐培元;黄佶

上海交通大学;上海交通大学;;上海交通大学;中科院上海冶金研究所博士研究生

THE EFFECT OF PRIOR AUSTENITE GRAIN SIZE UPON THE SUSCEPTIBILITY OF 40CrNiMoA STEEL TO STRESS CORROSION CRACKING AND CORROSION FATIGUE IN DISTILLED WATER

Yang Zhengrui Xu Peiyuan Huang Ji(Shanqhai Jiao Tong University)

全文: PDF(1245 KB)

摘要: 本文作者研究了不同冶炼条件和不同奥氏体化温度热处理的40CrNiMoA钢试样在蒸馏水中的应力腐蚀和腐蚀疲劳行为,测定了试样的原始奥氏体晶粒度,对晶界杂质偏聚情况进行了Auger电子能谱分析,对应力腐蚀和腐蚀疲劳断裂的初始阶段进行了扫描电镜断口观察。根据实验结果,作者认为高强度钢40CrNiMoA在蒸馏水中的应力腐蚀和腐蚀疲劳行为主要与原始奥氏体晶粒度有关。晶粒大小与裂纹前端塑性区尺寸两者的相对比较决定了断裂方式,从而决定了材料的应力腐蚀和腐蚀疲劳萌生和扩展的难易程度。

Abstract：In the present work, the effect of prior austenite graiain size upon the stress corrosion cracking(SCC) and corrosion fatigue (CF)of 40CrNiMoA steel in distllied water was studied. The impurity segregations at grain boundaries of various prior austenite grain sizes resulted from different heat treatments were analysed by using Auger electron spectroscopy. The initial crack areas of fracture surfaces after either SCC or CF tests were observed under SEM. It was concluded that the behavior of both SCC and CF of 40CrNiMoA high strength steel in distilled water, in terms of its crack initiation as well as crack propagation, was mainly associated with the grain size, and the cracking modes were dependent upon the interactive relation between the grain size and the plastic zone ahead of the crack tips under tri-axial tensile stressing condition, thus determining the susceptibility to cracking.

收稿日期: 1987-06-25

	服务

	把本文推荐给朋友
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章
	杨正瑞
	徐培元
	黄佶
44.8K

引用本文:

杨正瑞;徐培元;黄佶. 原奥氏体晶粒度对40CrNiMoA钢在蒸馏水中的应力腐蚀和腐蚀疲劳断裂过程的影响[J]. 中国腐蚀与防护学报, 1987, 7(3): 189-197.
. THE EFFECT OF PRIOR AUSTENITE GRAIN SIZE UPON THE SUSCEPTIBILITY OF 40CrNiMoA STEEL TO STRESS CORROSION CRACKING AND CORROSION FATIGUE IN DISTILLED WATER. J Chin Soc Corr Pro, 1987, 7(3): 189-197.

链接本文:

https://www.jcscp.org/CN/ 或 https://www.jcscp.org/CN/Y1987/V7/I3/189

[1] 杨正瑞;徐培元,上海金属.1． 53(1982)
[2] 徐培元;杨正瑞,上海金属,4． 26(1983)
[3] Sastry, C. N.; Wood. W. E., Sample Quarterly, 1, 27(1981)
[4] 应赖雄:田中启介:林邦夫.材料,306,196(1979)
[5] Padmanabhan, R.; Wood, W. E., Met. Trans. 14A, 2347(1983)
[6] 黄佶.上海交通大学硕士论文(1984)
[7] 林栋梁;吴建生,金属学报,20,A62(1984)
[8] Ogura, T.; McMahon. Jr., C. J.; Feng, H. C.; Vitek. V., Acta. Metall.. 26, 1317(1978)
[9] Clayton, J. Q.; Knott, J. E., Met. Sci., 16, 145(1982)
[10] Briant, C. L.; Banerji, S. K., Met. Trans., 13A, 827(1982)
[11] Rice, J. J.; Johoson, M. A.. Inelastic Behavier of Solids,(M. F. Kannien et al. ed.), MeGraw Hill, New York,(1970)
[12] Gao, M.; Lu, M.; Wei, R. P., Met. Trans. 15A, 735(1984)
[13] Lessar, J. F.; Gerberich, W. W., Met. Trans. 7A, 953(1976)

No related articles found!

Viewed

Full text

Abstract

Cited

Shared

Discussed