Please wait a minute...
材料研究学报  2010, Vol. 24 Issue (2): 217-224    
  研究论文 本期目录 | 过刊浏览 |
Mo对Nb--Mo--V微合金化钢中碳化物析出的影响
王泽民  朱晓勇  刘文庆
上海大学微结构研究重点实验室 上海 200444
Influence of Mo on Tempering Precipitation in Nb–Mo–V Microalloyed Steels
WANG Zemin ZHU Xiaoyong LIU Wenqing
Key Laboratory of Advanced microanalysis; Shanghai University; Shanghai 200444  
引用本文:

王泽民 朱晓勇 刘文庆 . Mo对Nb--Mo--V微合金化钢中碳化物析出的影响[J]. 材料研究学报, 2010, 24(2): 217-224.
, . Influence of Mo on Tempering Precipitation in Nb–Mo–V Microalloyed Steels[J]. Chin J Mater Res, 2010, 24(2): 217-224.

全文: PDF(941 KB)  
摘要: 

将两种Mo含量不同的Nb--Mo--V微合金钢在1200℃固溶0.5 h后淬火, 然后在450--650℃间不同温度回火4h, 研究Mo含量对其在回火过程中组织变化和碳化物形成的影响。结果表明:低Mo含量微合金钢样品的硬度峰值出现在550℃回火, 高Mo含量的出现在600℃回火;在650℃回火后, 高Mo含量样品中碳化物颗粒尺寸比低Mo含量的小。其原因是, Mo偏聚在碳化物外层抑制了Nb、V从铁素体基体扩散进入碳化物, 并降低了基体中C和合金元素向碳化物扩散的速率, 从而抑制了碳化物颗粒长大。

关键词 金属材料 微合金钢 三维原子探针 碳化物 回火    
Abstract

Nb–Mo–V micro–alloyed steels with different contents of Mo were tempered at 450–650℃  for 4 h after solution treatment at 1200℃ for 0.5 h, The Influences of Mo on the microstructureand the process of the carbides formation had been investigated by using three dimensional atom probe (3DAP) transmission electron microscopy (TEM). The results show that the hardness maximum of micro–alloyed steel with low Mo–contented appeared for tempering at 550℃, and that of high Mo–content sample appeared for tempering at 600℃; The carbides radius in high Mo–contented sample were smaller than that in low Mo–content sample tempering at 650 under TEM observation. That is due to Mo segregation at the carbides outer layer, inhibited the diffusion of the Nb and V from the matrix into the carbides, and also reduced the diffusion rate of C and alloyed element in matrix, so the growth of the particle was impeded.

Key wordsmetallic materials    micro–alloyed steel    three dimensional atom probe (3DAP)    carbide    Mo    tempering
收稿日期: 2009-09-07     
基金资助:

国家自然基金重点50931003上海大学研究生创新基金SHUCX092224资助项目.

1 K.Kuo, Carbides in chromium, molybdenum, and tungsten steels, J. Iron steel Inst., 173, 363(1953) 2 M.Assefopur–Dezfuly, B.A.Hugaas, Brownrigg. A, Fire resistant high strength low alloy steels, Mater Science and Technology., 6, 1210(1990) 3 H.Wada, R.D.Pehlke, Nitrogen solubility and Nitride formation in austenitic Fe–Ti alloys, Metall Trans.,16(4), 815(1985) 4 M.G.Akben, B.Bacroix, J.J.Jonas, Effect of vanadium and molybdenum addition on high temperature recovery, recrystallization and precipitation behavior of Niobium– based microalloyed steels, Acta Metall., 31(1), 161(1983) 5 M.M.Kenzie, A.J.Craven, C.L.Collins, Nanoanalysis of very fine VN precipitates in steel, Scripta Materialia., 54(1), 1(2006) 6 S.G.Hong, K.B.Kang, C.G.Park, Strain–induced precipitation of NbC in Nb and Nb–Ti microalloyed HSLA steels, Scripta Materialia., 46(2), 163(2002) 7 D.Isheim, R.P.Kolli, M.E.Fine, D.N.Seidman, An atom– probe tomographic study of the temporal evolution of the nanostructure of Fe Cu based high–strength low–carbon steels, Scripta Materialia., 55(1), 35(2006) 8 S.D.Erlach, H.Leitner, M.Bischof, H.Clemens, F.Danoix, D.Lemarchand, I.Siller, Comparison of NiAl precipitation in a medium carbon secondary hardening steel and C– free PH13–8 maraging steel, Mater Sci Eng A., 429(1–2), 96(2006) 9 E.V.Pereloma, I.B.Timokhina, K.F.Russell, M.K.Miller, Characterization of clusters and ultrafine precipitates in Nb–containing C–Mn–Si steels, Scripta Materialia., 54(3), 471(2006) 10 I.B.Timokhina, P.D.Hodgson, S.P.Ringer, R.K.Zheng, E.V.Pereloma, Precipitate characterisation of an advanced high–strength low–alloy (HSLA) steel using atom probe tomography, Scripta Materialia., 56(7), 601(2007) 11 LIU Qingdong, LIU Wenqing, WANG Zemin, ZHOU Bangxin, 3D atom probe characterization of carbides precipitated in the Nb–V microalloyed steel, Acta Mater Sin., 44(7), 786(2008) (刘庆冬, 刘文庆, 王泽民, 周邦新, Nb--V微合金钢中碳化物析出的三维原子探针表征, 金属学报, 44(7), 786(2008)) 12 LIU Qingdong, CHU Yuliang, WANG Zemin, LIU Wenqing, ZHOU Bangxin, 3D atom probe characterization of alloying elements partitioning in cementite of Nb–V microalloyed steel, Acta Mater Sin., 44(11), 1281(2008) (刘庆冬, 褚于良, 王泽民, 刘文庆, 周邦新, Nb--V微合金钢中渗碳体周围元素分布的三维原子探针表征, 金属学报,  44(11), 1281(2008)) 13 M.K.Miller, Atom Probe Tomography: analysis at the atomic level (New York, Kluwer Academic/Plenum Publishers, 2000) p.25 14 B.W.Lee, S.G.Hong, C.G.Park, K.H.Kim, S.H.Park, Influence of Mo on precipitation hardening in hot rolled HSLA steels containing Nb, Scripta Materialia., 43(4), 319(2000) 15 YONG Qilong, Secondary phase in steel (Beijing, Metallurgical Industry Press, 2006)p.59 (雍岐龙,  钢铁材料中的第二相  (北京:冶金工业出版社, 2006) p.59) 16 YE Dalun, HU Jianhua, Practical handbook of inorganic thermodynamic data, 2th edition, (Beijing, China Metallurgical Industry Press ,2002)p.1105 (叶大伦, 胡建华,  实用无机物热力学资料手册. 第二版, (北京, 冶金工业出版社, 2002) p.1105) 17 D.H.Ping, M.Ohnuma, Y.Hirakawa, Y.Kadoya, K.Hono, Microstructural evolution in 13Cr–8Ni–2.5Mo–2Al martensitic precipitation–hardened stainless steel, Mater Sci Eng A., 394(1–2), 285(2005)
[1] 毛建军, 富童, 潘虎成, 滕常青, 张伟, 谢东升, 吴璐. AlNbMoZrB系难熔高熵合金的Kr离子辐照损伤行为[J]. 材料研究学报, 2023, 37(9): 641-648.
[2] 宋莉芳, 闫佳豪, 张佃康, 薛程, 夏慧芸, 牛艳辉. 碱金属掺杂MIL125CO2 吸附性能[J]. 材料研究学报, 2023, 37(9): 649-654.
[3] 赵政翔, 廖露海, 徐芳泓, 张威, 李静媛. 超级奥氏体不锈钢24Cr-22Ni-7Mo-0.4N的热变形行为及其组织演变[J]. 材料研究学报, 2023, 37(9): 655-667.
[4] 邵鸿媚, 崔勇, 徐文迪, 张伟, 申晓毅, 翟玉春. 空心球形AlOOH的无模板水热制备和吸附性能[J]. 材料研究学报, 2023, 37(9): 675-684.
[5] 幸定琴, 涂坚, 罗森, 周志明. C含量对VCoNi中熵合金微观组织和性能的影响[J]. 材料研究学报, 2023, 37(9): 685-696.
[6] 欧阳康昕, 周达, 杨宇帆, 张磊. LPSOMg-Y-Er-Ni合金的组织和拉伸性能[J]. 材料研究学报, 2023, 37(9): 697-705.
[7] 徐利君, 郑策, 冯小辉, 黄秋燕, 李应举, 杨院生. 定向再结晶对热轧态Cu71Al18Mn11合金的组织和超弹性性能的影响[J]. 材料研究学报, 2023, 37(8): 571-580.
[8] 熊诗琪, 刘恩泽, 谭政, 宁礼奎, 佟健, 郑志, 李海英. 固溶处理对一种低偏析高温合金组织的影响[J]. 材料研究学报, 2023, 37(8): 603-613.
[9] 刘继浩, 迟宏宵, 武会宾, 马党参, 周健, 徐辉霞. 喷射成形M3高速钢热处理过程中组织的演变和硬度偏低问题[J]. 材料研究学报, 2023, 37(8): 625-632.
[10] 由宝栋, 朱明伟, 杨鹏举, 何杰. 合金相分离制备多孔金属材料的研究进展[J]. 材料研究学报, 2023, 37(8): 561-570.
[11] 任富彦, 欧阳二明. g-C3N4 改性Bi2O3 对盐酸四环素的光催化降解[J]. 材料研究学报, 2023, 37(8): 633-640.
[12] 王昊, 崔君军, 赵明久. 镍基高温合金GH3536带箔材的再结晶与晶粒长大行为[J]. 材料研究学报, 2023, 37(7): 535-542.
[13] 刘明珠, 樊娆, 张萧宇, 马泽元, 梁城洋, 曹颖, 耿仕通, 李玲. SnO2 作散射层的光阳极膜厚对量子点染料敏化太阳能电池光电性能的影响[J]. 材料研究学报, 2023, 37(7): 554-560.
[14] 秦鹤勇, 李振团, 赵光普, 张文云, 张晓敏. 固溶温度对GH4742合金力学性能及γ' 相的影响[J]. 材料研究学报, 2023, 37(7): 502-510.
[15] 刘天福, 张滨, 张均锋, 徐强, 宋竹满, 张广平. 缺口应力集中系数对TC4 ELI合金低周疲劳性能的影响[J]. 材料研究学报, 2023, 37(7): 511-522.