油套管用P110钢在元素硫环境中腐蚀规律的研究

中国腐蚀与防护学报

2010, Vol. 30

Issue (2): 161-165

会议论文

本期目录 | 过刊浏览

油套管用P110钢在元素硫环境中腐蚀规律的研究

蔡晓文;戈磊;陈长风;于浩波

中国石油大学（北京）材料科学与工程系北京 102249

CORROSION BEHAVIOR OF P110 TUBE AND CASING STEEL IN THE ENVIRONMENT OF SULFUR DEPOSITION

CAI Xiaowen; GE Lei; CHEN Changfeng; YU Haobo

Department of Materials Science and Engineering; China University of Petroleum; Beijing 102249

全文: PDF(915 KB)

摘要:

通过模拟普光气田元素硫沉积环境，调节腐蚀体系的温度和酸性，利用腐蚀失重法探讨了油套管用P110钢硫沉积环境下的失重规律；用 SEM、EDS、XRD研究产物膜的形态及成分，用电化学方法检测产物膜的离子选择性对腐蚀速率的影响。实验结果表明，元素硫的歧化反应提高腐蚀介质的酸性，增加介质中比Cl^-极性更强的侵蚀性离子HS^-/S^2-，因而显著地提高P110钢的腐蚀速率，且随腐蚀温度及时间的增长P110钢腐蚀速率先增大后减小，腐蚀产物由基体侧向外硫含量升高。膜电位测量的结果表明，同一温度条件下，腐蚀速率的增加与产物膜阴离子选择性的增强具有密切关系。

关键词 ：元素硫, 硫沉积, 歧化反应, 膜电位

Abstract：

Corrosion rate of P110 steel was investigated by the mass loss method in sulfur deposition environment with different temperature and different acid of the experimental system that simulated the downhole environment of PUGUANG gas field. Meanwhile, the corrosion product scales were analyzed by SEM, EDS and XRD technology, and the method of electrochemistry was used to test the effect of sulfur to corrosion rate. The results showed that the reason why the corrosion rate greatly increased is the disproportionation reaction resulting in the increasing of H⁺ and HS^-/S^2- which were more aggressive than Cl^-. The corrosion rate firstly increased and then decreased with the temperature and time increasing, and the content of sulfur of corrosion products increased from the matrix to the outer layer. The result of film potential measure indicated that the increasing of corrosion rate was closely related to the inhancing of the anion selective of the corrosion product scales.

Key words： elemental sulfur sulfur deposition disproportionation reaction film potential

收稿日期: 2009-10-26

ZTFLH:

TG174.2

基金资助:

国家自然科学基金项目（50601029，50771104）资助

通讯作者: 戈磊 E-mail: gelei08@eyou.com

Corresponding author: GE Lei E-mail: gelei08@eyou.com

作者简介: 蔡晓文, 女,1982年生, 硕士生, 研究方向为金属的腐蚀与防护

	服务

	把本文推荐给朋友
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章
	蔡晓文
44.8K

引用本文:

蔡晓文;戈磊;陈长风;于浩波. 油套管用P110钢在元素硫环境中腐蚀规律的研究[J]. 中国腐蚀与防护学报, 2010, 30(2): 161-165.
SA Xiao-Wen. CORROSION BEHAVIOR OF P110 TUBE AND CASING STEEL IN THE ENVIRONMENT OF SULFUR DEPOSITION. J Chin Soc Corr Pro, 2010, 30(2): 161-165.

链接本文:

https://www.jcscp.org/CN/ 或 https://www.jcscp.org/CN/Y2010/V30/I2/161

[1] Yang Z X, Liu Z D, Gu T, et al. Field experimental study of electrochemical corrosion in the high sulfur gas field. [J]. Chem.Eng. Oil. Gas., 2006, 35(3): 222-224
    (杨仲熙, 刘志德, 谷坛等. 高含硫气田电化学腐蚀现场试验研究 [J]. 石油与天然气化工, 2006, 35(3): 222-224）
[2] Lin H C, Lu M, Cao C N, et al. Phase changes and its effects in the exploition of high H₂S gas well [J]. Corros. Sci. Prot. Technol., 1992, 4(4): 308-313
    (林海潮, 吕明, 曹楚南等. 特高含H₂S气井开采过程中可能发生的相态变化及其影响 [J]. 腐蚀科学与防护技术, 1992, 4(4): 308-313)
[3] Zhu S D, Bai Z Q, Lin G F, et al. Effect of H₂S partial pressure on corrosion rate of P110 steel under high Cl^-oil condition [J]. Corros. Prot., 2009, 30(5): 293-296
    (朱世东, 白真权, 林冠发等. 高Cl^-条件下H₂S分压对P110钢腐蚀速率的影响 [J]. 腐蚀与防护, 2009, 30(5): 293-296)
[4] Zhu S D, Bai Z Q, Liu H, et al. Influence factors of CO₂ corrosion rate in oil and gas field [J].Petrochem. Ind. Inner Mong., 2008,(5): 6-10
    (朱世东, 白真权, 刘会等. 影响油气田CO₂腐蚀速率的因素研究 [J]. 内蒙古石油化工, 2008, (5): 6-10)
[5] Deng T, Ke J J, Chen J Y. Research on kinetics of disproportionation reaction for sulfur [J]. Noferrous Met. (Extra.Metall.), 1983, (1): 49-55
    (邓彤, 柯家骏, 陈家镛. 元素硫的歧化反应动力学研究 [J]. 有色金属（冶炼部分），1983，（1）: 49-55)
[6] Zhang Y, Zhao P. Failure analysis of drill pipe φ127 mm ×9.19 mm IEU S-135 [J]. Steel Pipe, 2003, 32(4): 10-16
    (张毅, 赵鹏. φ127 mm ×9.19 mm IEU S-135钻杆腐蚀失效分析 [J]. 钢管, 2003, 32(4): 10-16)
[7] Liu H, Zhao G X, Li G P, et al. Corrosion behavior of 5Gr and P110 steel in the environment of H$_2$S [J]. Petrochem. Ind. Inner Mong,2008, 18: 15-18
    (刘会，赵国仙，李国平等. H₂S气体对5Cr和P110钢的腐蚀行为 [J]. 内蒙古石油化工, 2008, 18: 15-18)
[8] Shi K, Chen B S. Research on new production process of insoluble sulfur [J]. Chem.Eng. J., 1996, 47(2): 254-258
    (施凯, 陈秉铨. 不溶性硫磺生产新工艺的研究 [J]. 化工学报, 1996, 47(2): 254-258)
[9] Li Z X. Insoluble sulfur[J]. S P BMH related Eng., 2001, (1): 15-19
    (李正西. 不溶性硫磺 [J]. 硫磷设计与粉体工程, 2001, (1): 15-19)
[10] Wang Z X, Chen M C. High temperature stability for the insoluble sulfur [J]. Chem. Guangzhou, 2004, 29(3): 10-14
     (王志霞, 陈鸣才. 不溶性硫磺的高温稳定性 [J]. 广州化学, 2004, 29(3): 10-14)
[11] Cao L C. Test of ions exchange membrane selective permeability [J]. J. Wuhan Inst. Chem. Technol., 1999, 21(3): 30-33
     (曹连城. 离子交换膜选择透过性的测定 [J]. 武汉化工学院学报, 1999, 21(3): 30-33)

[1]	沈秋燕,刘宏芳,刘烈炜. 沉积硫对FeS及FeCO₃膜结构及耐蚀性影响[J]. 中国腐蚀与防护学报, 2016, 36(1): 79-86.
[2]	陈宇, 陈旭, 刘彤, 王冠夫, 王彦亮. 成膜电位对316L不锈钢在硼酸溶液中电化学行为的影响[J]. 中国腐蚀与防护学报, 2015, 35(2): 137-143.
[3]	刘佐嘉程学群李晓刚刘小辉. 点缺陷模型在2205双相不锈钢中的应用[J]. 中国腐蚀与防护学报, 2013, 33(2): 90-96.

Viewed

Full text

Abstract

Cited

Shared

Discussed