Please wait a minute...
中国腐蚀与防护学报  1988, Vol. 8 Issue (4): 267-273    
  研究报告 本期目录 | 过刊浏览 |
18-8不锈钢在不同极化电位下的腐蚀磨损行为
李诗鋽;李明;姜晓霞;张丹
中国科学院金属研究所;中国科学院金属研究所;中国科学院金属研究所;中国科学院金属研究所
THE CORROSIVE WEAR PERFORMANCE OF 304 STAINLESS STEEL IN SULFURIC ACID AT DIFFERENT POLARIZATION POTENTIALS
Li Shizhuo Li Ming Jiang Xiaoxia and Zhang Dan (Institute of Metals Research; Academia Sinica)
全文: PDF(960 KB)  
摘要: 本文介绍用自制的销环式腐蚀磨损机研究18-8不锈钢在1NH_2SO_4介质中不同电位区的腐蚀磨损行为。结果表明载荷与腐蚀磨损间仍然存在线性关系。阴极极化区内腐蚀受到抑制,单纯磨损作用造成的材料流失量不大;过钝化区内腐蚀与磨损协同作用而加速材料流失:钝化区内由于磨损导致钝化膜破裂,且载荷越大、电位越正材料流失越严重,故一般的阳极保护法不适用于腐蚀与磨损并存的情况。
Abstract:The corrosive wear performance of 304 stainless steel in sulfuric acid was determined in 1N H_2SO_4 at different polarization potentials by means of a pin-disc device. The linear relationship, with different slopes between corrosive wear and loads was confirmed. It is suggested that the removal of material in cathodic polarization region only results from mechanical wear, therefore linear relationship exists with a small sloper the synergy of corrosion and wear accelerates the removal of material in over-passive region, in which high linear slope appears; in passive region the breakdown of passive film results from shear stress, the higher of load and the more positive of potential, the more removal of material will be. So anodic protection is not suitable for corrosive wear of alloys.
收稿日期: 1988-08-25     
基金资助:国家自然科学基金资助项目的一部份

引用本文:

李诗鋽;李明;姜晓霞;张丹. 18-8不锈钢在不同极化电位下的腐蚀磨损行为[J]. 中国腐蚀与防护学报, 1988, 8(4): 267-273.
. THE CORROSIVE WEAR PERFORMANCE OF 304 STAINLESS STEEL IN SULFURIC ACID AT DIFFERENT POLARIZATION POTENTIALS. J Chin Soc Corr Pro, 1988, 8(4): 267-273.

链接本文:

https://www.jcscp.org/CN/      或      https://www.jcscp.org/CN/Y1988/V8/I4/267

[1] 岳钟英,周平安,史晋宏,固体润滑,7(2) ,65(1987)
[2] #12
[3] Schumscher, W.J., Wear of Materiaes,ASME 558, (1985)
[4] #12
[5] Kim, K. Y.; Bhattaeharyya, S.: Agarwala, V., Wear of Materials, ASME 772(1981)
No related articles found!