Please wait a minute...
中国腐蚀与防护学报  1990, Vol. 10 Issue (1): 35-42    
  研究报告 本期目录 | 过刊浏览 |
Zn—5%Al—RE合金镀浴对低碳钢板的溶解腐蚀
李扬宗;刘川
华南理工大学;华南理工大学
CORROSION OF LOW CARBON STEEL (AY1) IN Zn—5%Al—RE ALLOY BATH
Li Yangzong Iiu Chuan (South China and University of Technology)
全文: PDF(2256 KB)  
摘要: 本工作研究了热浸镀 Zn-5%Al-RE 合金过程中低碳钢板(AY 1)的溶解腐蚀。结果表明 I在490℃以上,腐蚀非常严重。合金层的生长动力学可分为两个阶段,第二阶段中合金层的持续剥落及溶解导致了铜板的严重腐蚀。RE 元素缩短了第一阶段合金层出现的孕育期,但对其生长动力学基本无影响,表明 RE 可能提高了 Zn-Al 共晶合金对钢板的润湿性,Al 则使第一阶段反应激活能提高,对钢板和合金的反应起到阻滞的作用。
Abstract:A study on the dissolution of low carbon steel(AY 1,0.09C:0.37Mn; 0.22Si;0.018P;0.017S)in Zn-5%Al-RE(where RE stand for rare earth) alloy bath is carried out.The results demonstrate that severe corrosion occurswhen the dipping temperature is above 490℃(for 10min).The growth kinetics of the alloying layer can be divided int two stages,The continuod spalling-dissolving of the alloying layer at the second stage is thought to be the main cause of the serious corrosion of the steel. The incubation period of the alloying layer at the first stage is shortened by adding RE,but RE has no effects on the growth kinetics.This may suggest that RE has an ability to increase the wettability of Zn Al eutectic alloy with the low carbon steel.The apparent activation energy increases with an increasing amount of A1 in the bath,this reveals the inhibiting effect of A1.
收稿日期: 1990-02-25     

引用本文:

李扬宗;刘川. Zn—5%Al—RE合金镀浴对低碳钢板的溶解腐蚀[J]. 中国腐蚀与防护学报, 1990, 10(1): 35-42.
. CORROSION OF LOW CARBON STEEL (AY1) IN Zn—5%Al—RE ALLOY BATH. J Chin Soc Corr Pro, 1990, 10(1): 35-42.

链接本文:

https://www.jcscp.org/CN/      或      https://www.jcscp.org/CN/Y1990/V10/I1/35

[1] Lynch,R.F.,J.Met.,39(8) ,34(1987)
[2] Goodwin,F.E.,Galfan;Galvaning Alloy.& Technogy,Second Edition,8,1983;Revised, 5,1984,Published by ILZRO Inc.
[3] Pelerin,J.,et al,金属表面技术,33(10) ,474(1932)
[4] Lynch,R.F.,Galfan Coated Steel for Upgraded Formability and Corrosion Resistance,Met.Bulletin Coated Coil Conf.,Chieagos,Illinois,Oct,(1985)
[5] 顾国成,吴文森,钢铁材料防蚀涂层,科学出版社,1987年2月第一版
[6] 李九岭,带钢连续热镀锌,冶金工业出版社,1981年11月第1版
[7] Uchiyama,Y.,et al,Rep.Fac.Eng.Nagasaki Univ.,(26) ,81(1986)
[8] 李扬宗,刘川,全国第一届热镀锌(铝)技木交流会论文,1988年4月,石家庄
[9] 孟荣祥,扬熙珍,中国腐蚀与防护学报,7(1) ,8(1987)
[10] Jones,R.D.;Denner,S.G.,Proc.INTERFINISHING 80,Oct.12-17,Kyoto,Japan
No related articles found!