Please wait a minute...
中国腐蚀与防护学报  2006, Vol. 26 Issue (3): 166-170     
  研究报告 本期目录 | 过刊浏览 |
微量锶对镁锰牺牲阳极显微组织和电化学性能的影响
侯军才;关绍康;任晨星;徐河;房中学;赵彦学
郑州大学材料学院
EFFECT OF SMALL ADDITION OF STRONTIUM ONMICROSTRUCTURE AND ELECTROCHEMICALPERFORMANCE OF Mg-Mn SACRIFICIAL ANODE
;;;;;
郑州大学材料学院
全文: PDF(458 KB)  
摘要: 采用OM、SEM、EDS、XRD及电化学测试等手段,研究了微量Sr对镁锰牺牲阳极显微组织和电化学性能的影响.结果表明,微量Sr的加入能够细化晶粒,当Sr含量从0增加到030mass%时,合金的晶粒尺寸由900 μm减小到80 μm.随着Sr含量的增加,阳极的电流效率升高,开路电位负移,当Sr加入量为0.10%时,电流效率和开路电位达到最佳,其值分别为54.5%和-1.73VSCE;进一步增加Sr的含量,阳极电流效率下降,开路电位正移.研究认为,Sr含量不超过0.10%时,晶界析出的Mg17Sr2(弱阴极相)和α-Mg基体(阳极相)组成了电偶对,阻碍了晶间腐蚀,减少了晶粒大块脱落,电流效率升高,同时晶粒细化,晶界面积变大,杂质相(阴极相)分布更均匀,开路电位负移;Sr含量大于0.10%时,过量的Mg17Sr2相作为阴极相加大了镁阳极的腐蚀,电流效率下降,开路电位正移.
关键词 锶镁锰牺牲阳极显微组织电化学性能    
Abstract:The effect of small addition of strontium on the microstructures and electrochemical performances was investigated by optical microscope (OM),X-ray diffractometer(XRD),scanning electron microscope (SEM),energy dispersive spectrometer (EDS)and electrochemical methods.The results show that the crystal grains are diminished with the small addition of Sr and the average grain size decreases from 900 μm to 80 μm when the Sr addition varies from 0 to 0.30%.When the addition of Sr is less than 0.1%,the efficiency is improved,and the open potential shifts negatively.The efficiency and the open potential of the anode will meet the peak values simultaneously with 0.1% Sr additio n which are 54.5% and -1.73VSCE.However,when the Sr addition is more than 0.1%,the efficiency is remarkably decreased,and the open potential shifts notably. The reasons that Sr addition affects the efficiency and the potential are mainly attributed to:(1)when the Sr addition is less than 01%,the microgalvanic cells which are established by the Mg17Sr2 phase(cathode) and theα-Mg matrix(anode),reduce the intergranular corrosion diminishing the particles falling and the efficiency increases.The refined microstructures by small Sr addition increasing the grain boundary areas induce more uniform distribution of the impurities,and the open potential shifts negatively;(2)when the Sr addition is more than 0.1%,more Mg17Sr2 phase pasticles act as the cathode,which increases the corrosion along the grain boundaries and the efficiency drops and the open potential shifts notably.
Key wordsSr    Mg-Mn sacrificial anode    microstructure    electrochemi cal performances
收稿日期: 2005-09-05     
ZTFLH:  TG146.2  
通讯作者: 侯军才     E-mail: houjuncai@gs.zzu.edu.cn

引用本文:

侯军才; 关绍康; 任晨星; 徐河; 房中学; 赵彦学 . 微量锶对镁锰牺牲阳极显微组织和电化学性能的影响[J]. 中国腐蚀与防护学报, 2006, 26(3): 166-170 .
. EFFECT OF SMALL ADDITION OF STRONTIUM ONMICROSTRUCTURE AND ELECTROCHEMICALPERFORMANCE OF Mg-Mn SACRIFICIAL ANODE. J Chin Soc Corr Pro, 2006, 26(3): 166-170 .

链接本文:

https://www.jcscp.org/CN/      或      https://www.jcscp.org/CN/Y2006/V26/I3/166

[1] 戴婷, 顾艳红, 高辉, 刘凯龙, 谢小辉, 焦向东. 水下摩擦螺柱焊接头在饱和CO2中的电化学性能[J]. 中国腐蚀与防护学报, 2021, 41(1): 87-95.
[2] 孙海静, 覃明, 李琳. 深海低溶解氧环境下Al-Zn-In-Mg-Ti牺牲阳极性能研究[J]. 中国腐蚀与防护学报, 2020, 40(6): 508-516.
[3] 王凯, 易耀勇, 卢清华, 易江龙, 江泽新, 马金军, 张宇. 基于窄间隙焊接的热模拟峰值温度对Q690高强钢腐蚀行为的影响[J]. 中国腐蚀与防护学报, 2018, 38(5): 447-454.
[4] 牛振国, 郭浦山, 叶宏, 杨丽景, 许赪, 宋振纶. Zn-7Mg合金热处理显微组织演变及耐蚀性能研究[J]. 中国腐蚀与防护学报, 2017, 37(4): 347-353.
[5] 滕彧,陈旭,何川,王义闯,王冰. 显微组织对X70钢在含有硫酸盐还原菌的3.5%NaCl溶液中腐蚀行为的影响[J]. 中国腐蚀与防护学报, 2017, 37(2): 168-174.
[6] 张建春,左龙飞,蒋金洋,麻晗,宋丹. 耐海水腐蚀钢筋00Cr10MoV的组织结构及性能研究[J]. 中国腐蚀与防护学报, 2016, 36(4): 363-369.
[7] 苏艳,张伦武,钟勇. 5A90铝锂合金显微组织及海洋大气环境腐蚀行为[J]. 中国腐蚀与防护学报, 2016, 36(3): 260-266.
[8] 马旭,李全安,井晓天. 热处理对Mg-10Gd-2.5Nd-0.5Zr合金组织和耐蚀性能的影响[J]. 中国腐蚀与防护学报, 2016, 36(2): 143-149.
[9] 暨波,张新明,张卓夫,叶凌英,李文健. Yb对2519A铝合金抗剥落腐蚀性能的影响[J]. 中国腐蚀与防护学报, 2015, 35(3): 279-286.
[10] 张金龙, 屠礼明, 谢兴飞, 姚美意, 周邦新. Zr-1Nb-xGe合金在400 ℃过热蒸汽中耐腐蚀性能的研究[J]. 中国腐蚀与防护学报, 2014, 34(2): 171-177.
[11] 曹彩红 梁成浩 黄乃宝. 镀铌不锈钢双极板的电化学性能[J]. 中国腐蚀与防护学报, 2013, 33(2): 123-128.
[12] 黄本生,江仲英,潘欢欢,袁鹏斌,刘清友. 热处理工艺对G105钻杆材料抗腐蚀性能的影响[J]. 中国腐蚀与防护学报, 2012, 32(1): 67-69.
[13] 郭海艳,朱君秋,邵艳群,唐电. 表面活性剂辅助制备钛阳极的电化学性能[J]. 中国腐蚀与防护学报, 2010, 30(6): 449-452.
[14] 米丰毅,王向东,汪兵,陈小平,彭云. 显微组织对低碳钢耐蚀性的影响[J]. 中国腐蚀与防护学报, 2010, 30(5): 391-395.
[15] 马力,李威力,曾红杰,闫永贵,侯保荣. 低驱动电位Al-Ga合金牺牲阳极及其活化机制[J]. 中国腐蚀与防护学报, 2010, 30(4): 329-332.