连续充氢条件下30CrMnSiA钢的(Ⅰ+Ⅱ)复合型氢致开裂

中国腐蚀与防护学报

1991, Vol. 11

Issue (2): 163-168

研究报告

本期目录 | 过刊浏览

连续充氢条件下30CrMnSiA钢的(Ⅰ+Ⅱ)复合型氢致开裂

高桦;曹卫杰

上海工程技术大学;上海工程技术大学

HYDROGEN ASSISTED CRACKING OF 30CrMnSiA STEEL UNDER CONTINUOUSLY HYDROGEN CHARGING AND (Ⅰ+Ⅱ) MIXED MODE LOADING CONDITION

Gao Hua Cao Weijie (Shanghai University of Engineering Science)

全文: PDF(356 KB)

摘要: <正> 随着高强钢的广泛应用及使用环境的复杂化,材料在工作环境中的氢脆问题日趋突出,与此有关的工程断裂事故屡见不鲜。工作于氢环境中的构件大多处于连续充氢条件下,并且由于实际构件内部缺陷形式多样、载荷复杂、裂纹方向各异,缺陷常常在复合型受载条件下扩展。但是,自从60年代将断裂力学引入氢致开裂研究以来,迄今主要研究了Ⅰ型受载条件下的开裂问题。对复合型应力腐蚀和氢致开裂只是研究了Ⅲ型及(Ⅰ+Ⅱ)复合型开裂,而对(Ⅰ+

Abstract：Hydrogen assisted cracking (HAC) of 0. 3%C, 1%Cr, 1%Mn, 1%Si steel under continuously hydrogen charging and (Ⅰ+Ⅱ) mixed mode loading conditions was studied. Experimental results showed that under mixed mode loading conditions from mode I through mode Ⅱ ,the critical stress intensity factor K_H for HAC increased firstly and then decreased,thus at some K_Ⅱ/K_Ⅰ ratio K_(Hmax) occurred. In both mode Ⅰ and mode Ⅱ cases, however,K_(ⅠH) and K_(ⅡH) were rather low,and sometimes K_(ⅡH) was even lower than K_(ⅠH).

收稿日期: 1991-04-25

基金资助:国家自然科学基金

	服务

	把本文推荐给朋友
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章
	高桦
	曹卫杰
44.8K

引用本文:

高桦;曹卫杰. 连续充氢条件下30CrMnSiA钢的(Ⅰ+Ⅱ)复合型氢致开裂[J]. 中国腐蚀与防护学报, 1991, 11(2): 163-168.
. HYDROGEN ASSISTED CRACKING OF 30CrMnSiA STEEL UNDER CONTINUOUSLY HYDROGEN CHARGING AND (Ⅰ+Ⅱ) MIXED MODE LOADING CONDITION. J Chin Soc Corr Pro, 1991, 11(2): 163-168.

链接本文:

https://www.jcscp.org/CN/ 或 https://www.jcscp.org/CN/Y1991/V11/I2/163

[1] John C. St., Gerberich W. W..Metall. Mrans.,4,589～594(1973)
[2] John C.F.St.,Scr. Metall.,9,141(1975)
[3] Pickens J. R., Gordon J. R., Green J. A. S., Metall. Trans., 14A,925(1983)
[4] Nichols F. A., Corrosion.39,449～451 (1983)
[5] 高桦,薛礼觉,金属学报,25,A48(1989)
[6] Wang Keren(王克仁),Xu Jilin(徐纪林).Gao Hua(高桦).SCIENTIA SINICA,XXII,579(1979)
[7] 高桦、王自强,杨成寿.周爱华,金属学报,15,A380(1979)
[8] Troiano A. R., Trans. ASM,52,54(1960)

No related articles found!

Viewed

Full text

Abstract

Cited

Shared

Discussed